Setting the safety stop duration
1. Confirm that you wish to change the duration of the safety stop by pushing
. The duration starts to flash.
2. Change the duration in increments of 1 minute by pushing or .
3. Confirm the selected duration with .
Setting the maximum partial pressure of oxygen (ppO
2
max
)
1. Confirm that you wish to change the ppO
2
max
by pushing . The current
value starts to flash.
2. Change the value in increments of 0.05bar by pushing or .
3. Confirm the selected value with .
The ppO
2
max
setting is valid for gas 1 and the deco gas.
Setting the time limit to reset the O
2
% mix to air
1. Confirm that you wish to change the time limit of the reset
by pushing
. The current setting starts to flash.
2. Change the time limit by pushing or .
(1 - 48hrs o
r no reset: "– – h")
3. Confirm the selected value with .
Enabling two-gas diving
1. Confirm that you wish to enable two-gas diving by pushing
.
"On" or "off"
starts to flash.
"On" indicates the deco gas is active, "off" indicates that only gas 1 will be used
for decompression calculations.
2. Switch between "on" and "off" with .
3. Confirm your choice with .
Selecting the units
1. Confirm that you wish to change the units by pushing . The selected units
are displayed (m / ft / °C / °F).
2. Push . "m" or "ft" starts to flash.
3. Switch with between "m" and "ft".
4. Confirm the selected unit with . "°C" or "°F" starts to flash.
5. Switch with between "°C" and "°F".
6. Confirm the selected unit with .
Selecting the water type
1.
Confirm that you wish to change the selected water type by pushing .
"On"
or "off" starts to flash.
"Salt on" indicates salt water, "salt off" indicates fresh water.
2. Switch with between "salt on" and "salt off".
Confirm the water type with .
46
IX Settings
IX UWATEC Aladin TEC 2G
Duration of the safety stop
ppO
2
max
Time limit to reset O
2
mix
to air
Setting the dive time alarm
1. Confirm that you wish to change the time of the dive time alarm or to switch it
on or off by pushing . The alarm time starts to flash.
2. Change the alarm time in increments of 5 minutes by pushing or .
3. Confirm the selected alarm time with .
"
On
"
or
"
Off
"
starts to flash.
4.
"
On
"
indicates
"
activated
"
,
"
Off
"
indicates
"
deactivated
"
.
Switch between
"
on
"
or
"
off
"
by pressing .
Confirm the selected status with . See also page 22.
