EMPTY DUST CONTAINER
When the dust container is full, you should empty it to maintain full suction
power.
The device must be switched off beforehand and the battery removed from the
motor unit (press the release button (14) before emptying the dust container).
1. Turn the dust container to separate it from the motor unit.
2. Hold the flap of the dust container over a waste bin and press the button
(10) to open the flap. Empty dust and dirt.
3. Close the flap again so that it clicks into place. Put the empty dust
container back into the device.
CLEANING THE DUST CONTAINER, THE CYCLONE INSERT
AND THE FILTER
When the wind tunnel is blocked, the machine will shut down automatically. The LED
on the battery will flash for 5 seconds and the machine will beep for 5 seconds. This
means you should clean the wind tunnel and wash the HEPA and sponge.
From time to time, you should remove and clean the dust container and the cyclone insert
with the HEPA filter, at the latest when you notice that the suction power is
deteriorating.
1. Turn the dust container (8) and remove it from the device. Empty it as
described in the chapter "Emptying the dust container".
2. Take the cyclone insert and the HEPA filter out of the dust container.
3.Knock out the dust from the cyclone, insert, and the sponge cover or clean
3. them with a brush.
4. You can also clean the cyclone insert, HEPA filter, and the sponge cover
under lukewarm water.
5. Rinse the dust container under lukewarm water, dry it with a soft cloth, and
then let it air dry completely.
6. After you have completed this, cover the sponge onto the HEPA filter
and install the HEPA filter into the cyclone insert and put them back into
the device and close the flap so that it engages.
Attention:
Before using, ensure all of the cleaned parts are totally dry.
The filter system must be installed to avoid the dust going into your operation system,
causing noise or a bad smell. If this happens, please stop and check your device.
