5.2 Unit dimensions (mm)
Observe the safety distances from the unit (calculated in mm).
5.3 Safety distances
Keep this information in mind when mounting the unit.
After unpacking, check that the delivery is complete and that all parts are free of possible
transport damage.
1. - hood
2. - reducer 150 - 120 mm
3. - non-return valve
4. - remote control
5.1 Package Contents
5. INSTALLATION
ATTENTION!
This unit is designed to be installed and used in a furniture body.
See the pictures
1
See the picture
2a 2b 2c 2d
Check that the built-in furniture is positioned horizontally and that it has sufficient load-
bearing capacity.
Note: Follow the manufacturer's specifications regarding the load-bearing capacity of the
built-in furniture.
Make sure that the built-in furniture withstands temperatures up to 90 °C.
Make sure that the built-in furniture allows for embedding even after the cutting work is
done.
1.
2.
3.
4.
5.4 Checking the furniture
See the picture 3
EN
5.5 Installation steps
Note! Do not connect the power cable until the installation is complete!
Note! When the hood and the equipment powered by energy other than electric work
simultaneously, the negative pressure in the room must not exceed (4 x 10 Bar). Get a
second person to help you with the installation.
1.Cut the installation gap in the cabinet wall under which the hood will be mounted.
Use the dimensions in the image (calculated in mm) as a guide.
-5
2. Insert the hood into the furniture body.
Make sure that the elastic clips are fixed on the furniture body on both sides. See the
images
4a
4b
3. Adjust screws 1, 2, 3, 4 until the flanges of both sides are fixed in the furniture body. See
the pictures 4d
5.6 Fitting the grease filters
ATTENTION!
By falling, the grease filter can damage the cooking zone below. Hold the
filter firmly when installing it.
For the installation of the grease filter/filters, see the image
5.7 Exhaust size (mm)
See the picture
5
Position and secure the flap on the hood connection.
5.8 Installation of the non-return valve
7
4c
6
22