7. Replace the caseback, making sure the black gasket sits firmly in
the case groove and the caseback properly aligns with the Watch
to ensure the buzzer will line up with the internal connections
(see note after Step 2).
8. Carefully reattach the straps so that the shorter piece with the
buckle attaches to the upper set of lugs.
INDIGLO
®
night-light
Electroluminescent technology used in the INDIGLO night-light
illuminates the entire Watch face at night and in low light
conditions.
Water resistance
Your Watch withstands water pressure up to 86 psi (equals
immersion to 164 feet or 50 meters below sea level). This 50-meter
resistance remains intact so long as you keep the lens, push
buttons, and case intact.
WARNING: TO MAINTAIN WATER RESISTANCE, DO NOT
PRESS ANY BUTTONS WHILE UNDER WATER.
While your Watch will resist water, you should not use this Watch
for diving, as it is not a diver’s Watch and you should rinse your
Watch with fresh water after exposure to salt water.
NOTE: THIS WATCH WILL NOT DISPLAY S+D OR HEART
RATE DATA WHEN OPERATED UNDER WATER.
71
If you choose to replace the battery yourself, carefully follow the
steps below:
1. Place the Watch face-down on a flat work surface.
2. Separate both halves of the Watch band using a small flat
screwdriver.
NOTE: You must install the back of the Watch (caseback) in the
same direction you removed it or the buzzer element will not
function after reassembly.
3. Using a 00 Phillips-head screwdriver, remove the four screws
that secure the caseback and set them aside. Carefully remove
the caseback and set it aside.
WARNING: ALWAYS KEEP THE WATCH FACE DOWN ON YOUR
WORK SURFACE. IF YOU TURN THE WATCH OVER
TO REMOVE THE SCREWS OR CASEBACK YOU
MAY LOSE THE SMALL ELECTRICAL
CONNECTORS INSIDE THE WATCH.
4. Carefully open the battery clamp and remove the battery.
5. Place a new CR2430 cell in the battery compartment, making
sure the side with the “+” marking faces you.
6. Reattach the battery clamp.
70
589-095006_W188_NA_EN_589-095006_W188_NA_EN 3/11/11 8:39 AM Page 70
