❖
Sync Timer & Chrono: This feature allows you to set the
timer and the chronograph to start and stop simultaneously so
you can record chronograph data when you use the timer.
You must turn the Sync Timer & Chrono setting off if you want
the timer to switch to the Chronograph, Finish, or Vertical
Mode at the end of a countdown in Timer Mode.
WATCH SETTINGS
Configure the following Watch settings:
❖
Night Mode® feature: When enabled, the INDIGLO® night-
light turns on when you press any button. This feature disables
itself after eight hours.
❖
Hourly Chime: When enabled, the Watch will chime at the top
of every hour.
❖
Button Beep: When enabled, the Watch will emit a beep when
you press any button.
❖
Mode Hiding: You can choose to show, hide, or disable the
following modes: Vertical, Finish, Lap Data, Summary, Timer,
Navigate, Waypoints, or Alarm. For example, if you hide
Navigate Mode, you will not see any information from this
mode unless you are using the GPS-3D Sensor. If you disable
Navigate Mode it will not show up at all until you enable it
again from Configure Mode.
67
HANDS-FREE SETTINGS
Hands-free features operate in conjunction with the GPS-3D
Sensor. They automate chronograph features, freeing you to focus
on your workout instead of operating your Watch.
Configure the following hands-free settings:
❖
Auto Split: This feature enables the chronograph to
automatically take splits based on intervals (when you set
intervals in Timer Mode), or by a distance, altitude, or a time
you determine. For instance, you can configure the Watch to
take a split every mile and then you can compare data for each
mile in Lap Data Mode after you complete your activity.
❖
Auto Start: This feature enables the chronograph to start
when you start moving. It may take a few seconds for the GPS-
3D Sensor to detect your movement, causing a slight delay in
start time.
❖
Auto Stop: This feature enables the chronograph to stop when
you stop moving. It may take a few seconds for the GPS-3D
Sensor to detect that you have stopped moving, causing a slight
delay in stop time.
NOTE: Even when enabled, you can still start and stop the
chronograph manually and take manual splits without
affecting the hands-free operation.
66
589-095006_W188_NA_EN_589-095006_W188_NA_EN 3/11/11 8:39 AM Page 66
