| 17
ENGLISH
To insert the bobbin
1 Place the bobbin (a) into the bobbin case making
sure that the thread feeds clockwise from the bobbin.
2 Draw the thread through the bobbin case slot.
3 Draw the thread under the tension spring and into
the delivery eye. Pull out about 10 cmof thread.
➀ Tension spring
4 Holding the bobbin case from the latch, position the
bobbin case into the shuttle and then release the
latch. The case should lock into place when the
latch is released.
Threading the upper thread
Threading the upper thread
• Place a spool of thread on the spool pin with the
thread coming off in a clockwise direction
• Raise the thread take up lever to its highest position
by turning the handwheel counterclockwise.
• Raise the presser foot.
1 Draw the end of the thread around the thread guide
➀ Thread guide
2 While holding the thread near the spool, draw the
end of the thread down along the right channel and
around the bottom of the guide plate.
3 Firmly draw the thread up along the left channel and
slip the thread into the slit of the thread take up lever
from right to left and down into the take up lever eye.
4 Slide the thread behind the needle bar thread guide
on the left.
➁ Needle bar thread guide
5 Thread the needle from front to back.
