6.4.3 Additional LNC settings/LNC properties
When you have completed setting the switching matrix of your DVB
receiver in accordance with your antenna installation, you should
check the remaining settings for the reception installation, and adjust
the settings where necessary.
> Use the arrow keys left/right to move the marker to the
column Configuration.
> In the line on which you wish to check or adjust the settings,
use the arrow keys up/down to mark the field
Continue.
> Confirm by pressing OK.
A sub-menu will be displayed, allowing you to adjust LNC set-
tings or to set up a test transponder. (Fig. 6-9)
The following settings can be made:
LNC Type
> In this line, use the arrow keys left/right to enter the type
of LNC you are using. The options available are Single
LNC, Quatro LNC, DisiCon 1 LNC, DisiCon 2 LNC,
DisiCon 4 LNC, C-Band LNC and a User LNC for
manual entry of LNC data.
> Press OK to accept the setting.
Test transponder
The following items of this menu should only b e entered if you wish
to check the signal of a satellite.
Transponder frequency
In this line, use the numeric keys to enter a frequency on which
digital programmes are broadcast.
Polarisation
Use the arrow keys up/down to enter the desired polarisation
plane (horizontal or vertical).
Symbol rate
The symbol rate indicates the volume of data being transmitted per
second. This could be, for instance, 27500 (i.e. 27500 symbols per
second). Enter the appropriate symbol rate using the numeric
keys.
User LNC
If you have entered User LNC under the DiSEqC type, additional
settings may be made:
20
(Fig. 6-9)
