161727
23
Verklein
Vergroot
Pagina terug
1/32
Pagina verder
1-Introduction
TASCAM CD-RW900 23
5−Recording
Advanced recording
Fade-in and fade-out recording
At the beginning and end of recording, fade-in and
fade-out effects can be performed.
1 During stop or recording standby mode, set the op-
eration using the following menu options on the REC
sub-menu (refer to “Operation basics” on page 14).
FADE IN?
The length of the fade in to the normal level can be
set between 1 and 30 seconds in 1-second incre-
ments (default setting: 3 seconds).
FADE OUT?
The length of the fade out into complete silence
can be set between 1 and 30 seconds in 1-second
incre-ments (default setting: 3 seconds).
The display shows
Fade Out>XXs
or
Fade In>XXs
.
2 In recording standby mode, press the FADER key
on the remote control.
Recording begins and the sound fades in. After the
preset fade-in time, the sound is at normal level.
3 During recording, press the FADER key on the re-
mote control when you wish to fade-out the sound.
Fade-out begins with
Fade Out
ashing on the dis-
play then the unit enters recording standby mode.
4 Press the STOP key and the PMA writing will begin.
NOTE
Fade-in or fade-out function can be operated only
pressing the FADER key on the remote control unit.
Synchronized recording basically means that recording
will begin automatically when a signal is received, and
will stop when the signal ends.
Use the SYNC REC key to select the synchronization
mode. The synchronization mode determines the auto-
mated start and stopping of recording when a signal is
received.
During stop or recording stancby mode, repeated
presses of this key cycle through the fol-lowing modes:
Sync ALL: The
SYNC
indicator lights up.
Sync 1: The unit stops when a selected track is n-
ished and the
SYNC
indicator ashes
Sync OFF: Turns Sync recording function off
After the synchronization mode is selected, the record
ready mode must then be entered (you cannot reverse
the order of these steps).
Starting playback of the source automatically starts re-
cording on the CD-RW900 if Sync ALL or Sync 1 has
been selected (see “Sync recording” below) and manual
record start is disabled. If Sync OFF is selected, the re-
cording must be started manually.
Synchronaized recording
Sync recording
1 While recording standby mode, press the SYNC
REC key repeatedly to select Sync ALL or Sync 1.
2 Set the signal detection threshold level. Use the
SYNC LEVEL option in the REC sub-menu (refer to
“Operation basics” on page 14).
Rotate the MULTI JOG dial to adjust the level. The
level can be set from -72 dB to -24 dB in 6 dB incre-
ments. The default setting is -24 dB.
Press the MENU key or push the MULTI JOG dial to
enter and return to recording standby mode.
3 Input the source signal.
Recording begins automatically when the source
signal is detected. The source signal should be high-
er than the adjusted threshold level.
NOTE
After the mode is set, more than one second of
signal under the adjusted threshold level is required
to start recording automatically, otherwise, the unit
does not begin recording even it detects the signals.
Start of recording
level
time
Noise level
23

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Tascam cdrw900 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Tascam cdrw900 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,15 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info