611445
21
Verklein
Vergroot
Pagina terug
1/48
Pagina verder
USER GUIDE
19
STEREO INPUT CHANNELS
Each stereo input channel comprises two pairs of inputs per channel strip:
1 INPUTS STE-1/2/3/4
These inputs accept 3-pole `A gauge (TRS) jacks. Use these inputs for sources such as keyboards, drum
machines, synths, tape machines or processing units. The inputs are BALANCED for low noise and top
quality from professional equipment, but you can use UNBALANCED sources by wiring up the jacks as
shown in the “Wiring it Up” section earlier in this manual, although you should then keep cable lengths as
short as possible. Mono sources may be used by plugging into the left jack only.
2 GAIN
The GAIN control sets the level of the channel signal.
3 RETURNS RET-1/2/3/4
These inputs are unbalanced on RCA phono connectors, and are intended for use with CD players, DAT
machines or Hi-Fi equipment. Alternatively they may be used as simple effects returns or stereo instrument
inputs.
4 GAIN
The GAIN control sets the input level to the channel, allowing matching to a wide range of line level sources.
5 EQUALISER
HF EQ
Turn to the right to boost high (treble) frequencies, adding crispness to percussion from drum machines,
synths and electronic instruments. Turn to the left to cut these frequencies, reducing hiss or excessive
brilliance. Set the knob in the centre-detented position when not required. The control has a shelving
response giving 15dB of boost or cut at 12kHz.
LF EQ
Turn to the right to boost low (bass) frequencies, adding extra punch to synths, guitars and drums. Turn to
the left to reduce hum, boominess or improve a mushy sound. Set the knob to the centre-detented position
when not required. The control has a shelving response giving 15dB of boost or cut at 60Hz.
6 AUX SENDS
These are used to set up a separate mixes for FOLDBACK, EFFECTS or recording, and the combination of
each the Aux Send is mixed to the respective Aux Output at the rear of the mixer. For Effects it is useful for
the signal to fade up and down with the fader (this is called POST-FADE), but for Foldback or Monitor feeds
it is important for the send to be independent of the fader (this is called PRE-FADE).
AUX SENDS 1 AND 2
These are always PRE-FADE and therefore most appropriate for foldback or monitor mixes or external
submix.
AUX SEND 3 AND 4
These are always POST-FADE for effects sends, external submix (or for centre Voice cluster or mono Tape
mix.
7
BALANCE
This control sets the amount of the channel signal feeding the Left and Right MIX or SUB buses, allowing
you to balance the source in the stereo image. When the control is turned fully right or left you feed only
that side of the signal to the mix. Unity gain is provided by the control in the centre-detented position.
8 MUTE
All outputs from the channel are enabled when the MUTE switch is released and muted when the switch is
down.
21

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Soundcraft M4 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Soundcraft M4 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,64 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Soundcraft M4

Soundcraft M4 Gebruiksaanwijzing - Deutsch - 44 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info