Page 38 BASL - 02 - V03
User manual
UK
4.1.6 Close the lid of the
cable compartment.
Attention:
The mains cable must not
be drawn around corners or
over sharp edges, or be
jammed, and should not rest
on or hang from warm
objects.
4.1.7 Switch on mains
switch O-I. The machine is
now under current but only in
standby operation.
This action is not necessary
with the coin slot option.
4.1.8 Now press the
operating button ON/OFF
.
The relevant indicator (1a)
lights up and the machine
starts heating up. At the same
time the water pump starts
and fills the system with water,
as well as automatically
ventilating the machine.
4.1.9 Fill coffee beans into
the beans container (Quantity
approx. 500g). Seal the beans
container well with the lid.
Note:
Only pure coffee beans may
be used. Coffee with a
caramelized or aromatized
content must not be used.
If the monitoring indicator
blinks and the message
"Grinder lid" appears, then the
lid has not been fitted properly
and the machine is blocked
from preparing coffee.
4.1.10 Operational
readiness
When the temperature
monitoring indicator
lights
up green and the message
"Ready" appears in the
display, then the machine is
ready to use.
Note:
When the machine is put into
operation, it automatically
executes a rinse of the
brewing unit. This rinse always
takes place when the machine
has been switched on from a
cold state. During the rinsing
process (display message
Rinse) the machine is blocked
for the preparation of coffee.
If programmed:
Whenever the appliance is
switched off, an automatic
rinse cycle is performed. The
indicator flashes green. The
appliance is then automatically
switched to Standby mode
(the indicator (1b) flashes red)
4.1.11 Now press dispenser
button 6 and the first coffee is
delivered. This coffee
however, is not tasty, as the
coffee channel of the grinder
must first be filled. Please only
drink the next coffee that is
dispensed.
Attention:
Never take the machine into
operation without water. On
hygienic grounds you are
recommended, after long
breaks such as holiday
periods, to first rinse the
machine through by means
of the hot water nozzle
before using it again.
If during the rinsing process
the
appears, the water tank
is incorrectly located and there
is air in the system. Insert the
water tank correctly and vent
the machine by pressing the
hot water button
. Wait until
a steady water jet comes out.
Then press the hot water
button
again - the function
indicator disappears when a
coffee product button is
pressed.
4.2 Installation of the milk suction nozzle
You have received two milk suction nozzles (brown and
transparent) They have different passage diameters.
4.2.1 Milk suction nozzle
Push the milk suction nozzle
into the milk tube until it stops.
Important:
Without the milk suction
nozzle there is a risk that the
milk tube adheres to the
container bottom.
900'018.001
Ready
_
_
