appliance comes with a double graduation
scale, the one on the le -hand side
corresponds to medium-sized cups with
a capacity of approx. 125 ml, the one on
the right-hand side to smaller-sized co ee
cups. Take care not to exceed the indicated
maximum number of cups.
Always z switch o and allow the co ee
maker to cool down for about 5 minutes
before it is switched on again.
Warning! z Be careful not to ll water into
the reservoir immediately a er a brewing
cycle is complete as hot steam may escape
from the water nozzle.
To prepare lter co ee
Filling the water reservoir –
Open the water reservoir lid. Fill the reservoir
with the required amount of fresh cold water
and close the lid.
Inserting the paper lter –
Insert a size-4 paper lter, rst folding down
the perforated sides of the lter.
Adding ground co ee –
We recommend using ne ground lter
co ee, approximately 6 g = 1½ - 2 tsp. per
medium-sized cup (125 ml).
Preparing the jug –
Replace the jug back into the appliance.
Co ee maker with ”put on” lter holder:
Place the lter holder on top of the jug before
replacing the jug back into the appliance.
Co ee maker with pivoted lter holder:
Place the jug lid or the drip-through lid onto
the jug before replacing the jug back into the
appliance.
Starting the ltering process –
Plug in the appliance and switch on. e
ltering process begins.
Removing the jug –
When the ltering process is complete, i.e. all
water has run through the lter holder into
the jug, remove the jug to serve the co ee.
Co ee maker with ”put on” lter holder:
Remove the lter holder from the jug and
replace it by the jug lid.
Switching o the appliance –
Once the ltering process is complete, switch
o the appliance and unplug from the mains
supply socket.
Co ee maker with hotplate:
e hotplate will keep remaining co
ee warm
as lo
ng as y
ou leave it switched on. Switch the
appliance o a er use.
Co ee maker with drip-through lid
During the ltering process and while
pouring the co ee out, the drip-through lid
does not need to be removed and should
remain on the jug. To pour the co ee, press
the lever on the lid down to open it, when the
co ee may now pass out through the spout.
Co ee maker with vacuum jug
For technical reasons the screw cap does –
not close hermetically. erefore always
hold the jug in an upright position.
A vacuum jug accumulates heat energy. –
erefore the jug should preferably be
lled to its maximum capacity. If it is only
partly lled, the temperature will not be
held as e ciently. If you rinse out the jug
with hot water before use, the co ee will
be kept warm for a longer time.
Vacuum jug with glass ask
e glass ask of the jug is made of high
quality double-walled glass with a vacuum
in-between for better insulation. Any
marks inside the jug looking like bubbles or
scratches do not a ect its use nor its ability to
keep the temperature.
In case the glass is damaged for one or the
other reason as mentioned below, there is
a risk that the glass ask implodes. is
might happen quite some time a er the glass
ask has actually been damaged.
erefore do not drink out of the jug and z
do not put your hand into it. Always close
the jug with its screw cap. e co ee can
be poured out easily by half a turn of the
cap, without removing the cap. Do not
leave the vacuum jug unattended near
where children may reach it.
To prevent damage to the glass ask:
7
