charge indicator.
-
This appliance can remain on charge
indefinitely without damage or danger
and is therefore fully charged and ready
for use at all times.
-
Whilst charging, the adaptor will become
warm. This is perfectly normal and safe
and does not indicate a malfunction of
any kind.
-
If the vacuum cleaner is not being used
for a long period of time, the capacity of
the battery may decrease by a certain
amount. However, full capacity will be
restored after several charge/discharge
cycles.
Operation
-
Remove the vacuum cleaner from its
wall bracket.
-
If required, fit any of the nozzle
attachments provided to the suction
aperture.
-
Switch on the appliance using the On/Off
switch.
-
If the vacuuming power decreases during
operation, the appliance will
automatically switch off to prevent the
battery from being over-discharged.
Recharge the battery if this occurs.
Crevice tool
The crevice tool can be inserted into the
suction aperture to clean crevices, corners
and other areas difficult to reach.
Crevice brush
The crevice brush can be fitted to the crevice
tool and is suitable for cleaning uneven
surfaces such as computer keyboards etc.
Cleaning
General
● Before cleaning the appliance, remove
the vacuum cleaner from the wall
bracket.
● To avoid the risk of electric shock, do not
clean the appliance with water and do
not immerse it in water.
-
If necessary, the housing may be wiped
with a damp cloth. Wipe dry afterwards.
To empty the dust container
Reduced vacuuming power despite a fully
charged battery pack indicates that the dust
container and filter inlay must be emptied.
-
Hold the vacuum cleaner in your hand
-
Push the release button, open the dust
container in a downward and forward
direction, remove the filter and empty it.
-
The filter can be cleaned by slightly
tapping it or by using a brush.
Should the filter be visibly dirty, it should
be thoroughly cleaned with soapy water
(make sure to let it dry completely
afterwards) or replaced by a new one.
Only then may the vacuum cleaner be
used again.
Battery pack
● This appliance contains a nickel-metal
hydride (Ni-MH) rechargeable battery
pack, which may be removed for
replacement or disposal. When replacing
the battery pack, ensure that only an
original battery pack is used.
Ni-Mh
-
The battery compartment is located on
the underside of the appliance. Open the
compartment by removing the screw in
the compartment cover. Detach the two
wires from their respective terminals by
slightly opening the fixing screws. If a
new battery pack is installed, insert the
wires into their respective terminals and
tighten the screws again. When
connecting the wires, ensure that the
colours match the colour-coding on the
terminals (red to red).
● Remember to protect the environment.
Never dispose of old battery packs in
8
