781857
21
Verklein
Vergroot
Pagina terug
1/92
Pagina verder
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB | 21
Stroke limit for short logs, Fig. 10
Lower splitting knife position about 10 cm above ta-
ble.
Move splitting knife to the desired position
Release one operating arm
Switch motor off
Release the second operating arm
Undo the star grip screw (10a)
Push the stroke set rod (8) to the top until it is
stopped by the spring
Tighten the star grip screw (10a) again.
Switch motor on
Check upper position
Switching on and off (12)
Press the green button for switching on.
Press the red button for switching off.
Note: Check the function of the ON/OFF unit before
every use by switching on and off once.
Restarting safety in case of current interruption
(no-volt release).
In case of current failure, inadvertent pulling of the
plug, or a defective fuse, the machine is switched off
automatically.
For switching on again, press anew the green button
of the switch unit.
Splitting
Place the log on the table, hold it with both handles,
press the handles down. As soon as the splitting
knife enters the wood, push the handles down and
to the outside at the same time. This prevents the
wood from putting pressure on the holder plates.
Only split straight cut logs.
Split the logs in vertical position.
Never split in horizontal position or across.
Wear protective gloves when splitting.
End of work
Move the splitting knife to the lower position.
Release one operating arm.
Switch the machine off and pull the power plug.
Close the venting cap.
Observe the general maintenance instructions.
Electrical connection
The electrical motor installed is connected and ready
for operation. The connection complies with the ap-
plicable VDE and DIN provisions.
The customer‘s mains connection as well as the ex-
tension cable used must also comply with these reg-
ulations.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
10. Initial operation
Make sure the machine is completely and expertly as-
sembled. Check before every use:
The connection cables for any defective spots
(cracks, cuts etc.).
The machine for any possible damage.

The hydraulic system for leakage.
The oil level.
Checking the oil level (Fig. 13)
The hydraulic unit is a closed system with oil tank, oil
pump and control valve. Check the oil level regularly
before every use. Too low an oil level can damage the
oil pump. The correct oil level is approx. 10 to 20 mm
below the oil tank surface.
Note: The level of oil must be checked when the riving
knife is pulled back. If the oil level is at the lower notch,
then the oil level is at a minimum. Should this be the
case, oil must be immediately added. The upper notch
indicates the maximum oil level. The machine must
be on level ground. Screw in the oil dipstick fully, to
measure the oil level.
Functional test
Test the function before every use.
Action: Result:
Push both handles towards
below.
Splitting knife goes
down to approx. 10
cm above the table.
Let one handle loose, then
the other.
Splitting knife stops
in the desired po-
sition.
Let both handles loose. Splitting knife
returns to upper
position.
Check the oil level before every use – see chapter
“Maintenance“.
Venting, Fig. 14
Before working with the log splitter, vent the hydraulic
system.
Release the venting cap 6 by a few revolutions so
the air can escape from the oil tank.
Leave the cap open during the operation.
Before you move the log splitter, close the cap
again in order not to lose any oil.
If the hydraulic system is not vented, the enclosed air
will damage the gaskets and with it the complete log
splitter.
21

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Scheppach HL810 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Scheppach HL810 in de taal/talen: Duits, Engels, Frans, Italiaans als bijlage per email.

De handleiding is 3.75 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info