699577
18
Verklein
Vergroot
Pagina terug
1/43
Pagina verder
16 Installer Manual SATEL
The control panel can operate both with LCD and LED keypads in any configuration.
Notes:
We recommend keypad CA-10 LED-S v1.2 or newer to be used, because older keypads
LED S may work incorrect with keypad LCD v3.08 and next version (it regards to the
CA-10 KLED-M keypads, which were produced earlier, as well).
Only zone expanders with version 2 are allowed (label dated February 1998 or later).
The LCD display is fragile. It can be broken if the keypad is dropped to the floor!
After power-up of the KLED-S keypad, and when the control panel quits the service mode,
the keypad will remain disabled and will not react to pressing any keys for 5 seconds.
During that time the system settings are being read, and the keypad backlight is blinking
with a high frequency. Simultaneously, the keypad restores the automatic mode of keypad
illumination. The mode can be changed with the user function by holding down the key [9].
The keypads should be connected to the control panel connectors COM, +KPD, DATA,
CLK1, CLK2, CLK3, CLK4. The connectors COM, +KPD and DATA are common for all
partitions, while the connectors CLK1, CLK2, CLK3 and CLK4 determine the partition the
keypad belongs to. Where the system will be operated with less than 4 keypads, they should
be connected starting from the CLK1.
The keypads should not be connected in parallel to one CLK signal (one partition two
keypads). It applies to all LCD keypads, as well as the CA-10 KLED-S keypads. The only
exception are the CA-10 KLED keypads, which may be connected in parallel.
Each keypad should be connected with a separate cable. The distance between the keypad
and the panel can be up to 200 m. Unscreened cables are recommended to be used for
connecting the keypads.
It is recommended to use an untwisted unshielded cable 8x0,5 mm
2
(do not use twisted pair
cables). With recommended cable, the following distances between keypad and control panel
may be used to ensure appropriate power supply:
Distance Connection
№ of cable cores
LCD keypad LED keypad
up to 50 m
Power supply & ground
CLK & DATA signals
2 x 1
2 x 1
2 x 1
2 x 1
50–100 m
Power supply & ground
CLK & DATA signals
2 x 2
2 x 1
2 x 1
2 x 1
100–200 m
Power supply & ground
CLK & DATA signals
2 x 4
2 x 1
2 x 1
2 x 1
The keypads may be power supplied from the +KPD panel connector only. This output
can also be used for power supply of the keypad connected detectors.
As the LCD keypad current consumption is larger than that of the LED keypad (particularly
with active illumination of the keypad and display), it is important that resistance of the power
supply and ground lead-ins be taken into account when planning the cabling installation.
Caution: The supply voltage measured across the terminal block of LCD keypad with active
backlighting should not be less than 11 V.
The keypad tamper contact has no connection with the system anti-tampering circuit. Its state
is defined by the control panel, based on the data received from the keypad. When the
control panel is in the service mode, the tamper contact is not controlled.
18

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Satel CA-10 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Satel CA-10 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,56 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Satel CA-10

Satel CA-10 Gebruiksaanwijzing - Nederlands - 2 pagina's

Satel CA-10 Gebruiksaanwijzing - Deutsch - 2 pagina's

Satel CA-10 Gebruiksaanwijzing - Deutsch - 4 pagina's

Satel CA-10 Aanvulling / aanpassing - Deutsch - 64 pagina's

Satel CA-10 Aanvulling / aanpassing - Deutsch - 24 pagina's

Satel CA-10 Gebruiksaanwijzing - Deutsch - 26 pagina's

Satel CA-10 Installatiehandleiding - Deutsch - 44 pagina's

Satel CA-10 Gebruiksaanwijzing - English - 2 pagina's

Satel CA-10 Gebruiksaanwijzing - English - 2 pagina's

Satel CA-10 Gebruiksaanwijzing - English - 2 pagina's

Satel CA-10 Aanvulling / aanpassing - English - 60 pagina's

Satel CA-10 Aanvulling / aanpassing - English - 24 pagina's

Satel CA-10 Gebruiksaanwijzing - English - 24 pagina's

Satel CA-10 Snelstart handleiding - English - 11 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info