23501
9
Verklein
Vergroot
Pagina terug
1/28
Pagina verder
5
Front Panel Controls
FRONT PANEL
1 MIC IN
– Input connector for Low-Noise Microphone
pre-amp.
2 LINE IN–Input connector for Line level inputs.
3 INSERT – 1/4-inch TRS (TIP/RING/SLEEVE) connector
providing send and receive channel patch point for
outboard effects.
4 GAIN
– Used to set the input level of the mic pre and
line input.
5 LOW CUT – Bass roll off switch at 75Hz used to elimi-
nate unwanted low end rumble and hum.
6 HIGH FREQUENCY
– Controls the high band of the
Channel Equalizer, +/- 15 dB at 12KHz.
7 MID CUT/BOOSTThis control knob provides +/- 15
dB of boost or cut at the frequency set on the MID
SWEEP control on the mono input channels.
8 MID SWEEP – Control knob used to set the center
frequency of the mid band of the Channel Equalizer.
9 LOW FREQUENCY – Controls the low band of the
Channel Equalizer, +/- 15 dB at 80Hz.
10 AUX 1 – Auxiliary send that can be used with an
external effects processor, or to create a cue or moni-
tor mix.
11 PRE / POST switch
– Used to configure Aux 1 signal
routing from a Pre fader to a post fader send.
12 AUX 2/DSP – Post-fader auxiliary send that can be
used with an external effects processor, or to create a
cue or monitor mix, or to send a signal to the internal
DSP.
13 PAN – Controls the channel’s position between left
and right in the stereo bus.
14 3/4 MUTE LED
When illuminated, the display indi-
cates that the input channel is assigned to the ALT3/4
bus and is muted in the Left /Right Main Mix bus.
15 3/4 / MUTE switch
When engaged, the input chan-
nel is assigned to the ALT3/4 bus and is muted in the
Left / Right MAIN MIX bus.
16 SOLO LED
When illuminated, the display indicates
that the input channel is assigned to the SOLO bus.
17 SOLO switchWhen engaged, the input channel is
assigned to the SOLO bus.
18 PEAK – Red LED will illuminate indicating when the
GAIN has been adjusted too high.
19 LEVEL
– Audio taper fader provides smooth control
of level changes.
20 +4 / -10 switch – Used to set the line input sensitiv-
ity from –10dB when the switch is pressed in to +4dB
when this switch is out.
21 RIGHT LINE – 1/4-inch phone input connector for the
right line input for the stereo channels.
22 LEFT/MONO LINE - 1/4-inch phone input connec-
tor for the Left Line input for the stereo channels or a
mono input.
23 ALT 3/4 OUTPUTS jacks – Balanced, 1/4-inch phone
connectors carrying the signal from the ALT 3/4 bus.
24 CONTROL ROOM OUTPUT
– Left and Right Control
Room output connectors for connecting a monitor
system.
25 MAIN MIX OUTPUT (1/4-inch) – Left and Right Main
Mix balanced output 1/4-inch TRS connectors.
26 MAIN MIX OUTPUT (XLR)
– Left and Right Main Mix
balanced output XLR connectors.
27 AUX RETURN 1 – Left and right input jacks for con-
necting to the outputs of external line level sources
like those from effects processors.
28 AUX RETURN 2 – Left and right input jacks for con-
necting to the outputs of external line level sources
like those from effects processors.
29 FOOTSWITCH JACK
– 1/4-inch phone jack for con-
necting a standard footswitch used to turn the inter-
nal DSP effects on and off.
30 PHONES JACK
– Connect stereo headphones here.
31 AUX SEND 2 – Line level output from the Auxiliary 2
bus.
32 AUX SEND 1
– Line level output from the Auxiliary 1
bus.
33 2 TRACK OUTPUTS – Connect to the input of a DAT,
Cassette, Mini Disk or Hard Disk Recording system.
34 2 TRACK INPUTS – Connect the output from a DAT,
Cassette, Mini Disk or Hard Disk Recording system.
35 2 TRK LEVEL – Control knob used to set the level of
the source connected to the 2-track input.
36 VARIATIONS – Control knob used to select one of the
sixteen variations for each of the sixteen DSP effect
programs.
37 PROGRAMS – Control knob used to select one of the
sixteen DSP effect programs.
38 DSP PEAK
– LED indicator illuminates when the input
signal to the internal DSP is reaching an overload
level.
39 DSP MUTE switch – Used to turn the internal DSP
effects on and off.
40 ALT 3/4 TO MIX – Routes the ALT 3/4 to the Left /
Right MAIN MIX outputs. Use the ALT3/4 Level (55) to
set the volume.
41 2 TRK TO MIX
- Routes the Left / Right 2 track inputs
to the Left / Right MAIN MIX outputs. Use the 2 TRK
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Samson MDR1688 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Samson MDR1688 in de taal/talen: Engels als bijlage per email.

De handleiding is 6,67 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Samson MDR1688

Samson MDR1688 Gebruiksaanwijzing - Français - 28 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info