550805
20
Verklein
Vergroot
Pagina terug
1/26
Pagina verder
21
Battery Service
If the motorcycle is operated with an insufficient (low)
battery electrolyte level, sulfation and battery plate damage
may occur. Inspecting and maintaining the electrolyte
level is a simple, quick operation, therefore, it should be
performed frequently as indicated in the Service Schedule
(page 14-15)
1 The 12V-4AH battery 1. is mounted within the
frame center. Remove the battery cover and check
the battery electrolyte. The correct electrolyte level is
between the lower and upper level marks 3., 4. on the
battery case.
2 To correct the electrolyte level, remove the battery cell
caps from the cells needing level correction. For case
of cell level correction a small syringe or plastic funnel
should be used. Carefully add the proper amount of
distilled water to bring the electrolyte level of the cells
between the lower and upper marks.
1 Battery
2 Lower level marks
3 Upper level marks
For maximum battery performance and life, only distilled
water should be added, however, in an emergency situation
where electrolyte water or low and distilled water is not
available, drinking water or a low mineral content water can
be used. Reinstall the cell caps.
NOTE:
BATTERY REMOVAL MAY BE NECESSARY WHEN BATTERY
ELECTROLYTE (SPECIFICGRAVITY) READING IS BELOW
1,200, INDICATING THE NEED OF BATTERY RECHARGING,
OR WHEN THE BATTERY IS REMOVED FOR STORAGE.
3 Disconnect the ground (-) negative
cable connection and the positive(+) cable
last. Note the positioning of the cables, and the
battery mount rubber pads as well as the routing of the
battery vent tube. Before installing the battery,
clean the battery. Baking soda and water can be used
to remove any existing corrosion.
4 When considerable amount of night riding is
planned or if turn signal is used extensively, there
will be considerable drain on the battery. To adjust
the system to this condition, change the green
generator load from the red (normal change) connector
to the transparent covered connector (high charge).
This will provide a higher battery charging rate and
prevent possibility of battery becoming discharged.
NOTE:
1 ADD ONLY DISTILLED WATER TO THE BATTERY, NEVER
USE TAP WATER.
2 WHEN REPLACING THE BATTERY
INTO THE COMPARTMENT, MAKE SURE THAT THE
VENT TUBE OF THE BATTERY IS PROPERLY ATTACHED
TO AND NOT PINCHED OR BLOCKED.
3 IF UNUSUAL HIGH RATE OF BATTERY
ELECTROLYTE LOSS IS EXPERIENCED, CONSULT
YOUR SUPER DEALER FOR A CHECK.
Wheel removal
Removal of front and rear wheel is performed in the
following manner.
1 Front wheel
a. Raise the front wheel of the ground by putting the
motorcycle on the centre stand.
b. Remove speedometer cable and front brake
cable from the front brake panel assembly.
c. Remove the front axle nut.
d. Pull out the front axle and the front wheel can be
removed from the frame.
2 Rear wheel
a. Remove the chain guard..
b. Loosen the rear axle nut, sleeve nut, drive chain
adjusting nut and disconnect the drive chain at
the joint clip.
c. Remove the rear brake adjusting nut and remove
the rear brake rod from the brake arm.
d. Remove the rear torque arm bolt at the rear brake
panel.
e. Pull out the rear axle and the rear wheel can be
removed from the frame.
NOTE:
DURING REASSEMBLY, THE DRIVE CHAIN JOINT SHOULD
BE INSTALLED IN THE WAY THAT THE OPEN END WILL
FACE OPPOSITE TO THE DIRECTION OF ROTATION.
20

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw SMC Super 100 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van SMC Super 100 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,96 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info