Problem
Encountered
Probable Cause/Event Corrective/User Action
Robomow
operates during
rain
- Rain Sensor is disabled or its sensitivity is
set too low
- Enable the Rain Sensor and adjust its sensitivity if
required (Refer to Section 4.4.3).
- The Islands feature is set to On. In this case
the mower is searching for the base by
moving around the lawn. This special search
method takes more time, and may create an
impression that the mower is still mowing,
while in fact it is already searching for the
Base Station.
- No special action is required. For more information about
the Islands On/Off feature refer to Section 4.3.4.
Cut wire indicator
is flashing on
Power Box
- Cable is disconnected or damaged between
Power Box and the Base Station.
- Confirm cable is plugged in and wire leads are firmly
attached.
- Perimeter Wire is cut.
- Walk along Perimeter Wire.
Look for cuts or breaks in the
wire.
Repair with Robomow wire
splice connectors.
Poor connection
indicator is
flashing on Power
Box
- Poor connections - Check and repair all loose/poor or corroded connections.
- Twisted cables, or a screw terminal,
insulated with insulation tape is not a
satisfactory splice.
Soil moisture causes the conductors to
oxidize after a while. This may results in
broken circuit.
- Use the connectors supplied in the box. They are
waterproof and give a reliable electrical connection.
Robomow
is noisy and
vibrates
- Damaged or unbalanced blade
- Check if the lawn is free from branches, stones or other
objects that can damage a blade before operating the
Robomow.
- Replace the blade
LCD display
is in a foreign
language.
- The language setting was changed or not
correctly set.
- Press the CANCEL + DOWN buttons for more than 3
seconds. This is a shortcut to the Language menu.
Change the language.
Mowing or
charging times
are shorter than
usual.
- This behavior is normal at low temperatures
(below 15 ºC (59 ºF)).
- No action is required.
