644646
49
Verklein
Vergroot
Pagina terug
1/62
Pagina verder
38
Troubleshooting
Message
Displayed
Probable Cause/Event Corrective/User Action
Cross Outside
- The Perimeter Wire is too close to the edge.
- The lawn slope is too big.
- Robomow does not succeed to turn in place at
the edge and it causes the mower to slip out of
the area.
- Robomow has slipped out of the Perimeter
Wire loop because of a sloping area or wet
grass.
- Move the wire towards the inner side of the lawn.
- Do not include area with very steep slopes.
- Fill holes and pits in the ground.
- Increase the cutting height.
Drive Overheat
Cooling…
- The drive motors have been working under a
severe load for too long.
- No need to do anything.
- Robomow will renew the operation automatically as
soon as the drive motor will cool down.
Front Wheel
Problem
- The Front Wheel has left the ground for too
long time during operation.
- If Robomow has driven onto an obstacle, raising the
front end:
Remove or exclude the object from the mowing area.
- If Robomow is being used on a slope too steep for safe
mowing:
Exclude this from the mowing area.
- If High grass is preventing the front wheel from fully
riding on the ground:
Raise the cutting height.
- If the ground contains large holes or indentations where
the front wheel can drop into when passing across:
Fill these areas with dirt and level off.
Handle Lifted
- The handle is lifted while trying to start the
operation
- Push the carrying handle down back to its position to
enable automatic operation.
Key Pressed
- One of the operating panel buttons is
constantly pressed.
- Press
to confirm the message and to continue
operation. This message is displayed to inform only.
Keys Locked
- Child Lock feature has been activated.
- Press the
button and then press the
button.
Child Lock can be deactivated under the Settings
menu.
Mow Overheat
cooling…
- The mowing motor has been working under a
severe load for too long of a time.
- No need for action – Robomow will renew automatically
the operation, as the mowing motor will cool down.
No wire signal
- Power Box / Perimeter Switch is not turned on
or not connected to the zone intended to mow.
- Power Box may need to be restarted
- The Perimeter Wire is not connected to the
Base Station / Perimeter Switch.
- The Perimeter Wire is cut.
- Make sure the Base Station is connected to the mains
supply.
- Disconnect the Power Box from the mains power and
reconnect after 10 seconds.
- Check the Perimeter Switch is connected to the correct
zone and is turned on.
- Check the connection of the Perimeter Wire to the Base
Station / Perimeter Switch.
- Check for cut in the Perimeter Wire.
Rain detected
- The operation is delayed as Robomow detects
rain.
- Robomow should resume operation 30 minutes
after it stops to detect the rain.
- No need for action
- The message is displayed as long as rain/humid
conditions are detected by Robomow. Mowing will
restart automatically.
Raise Mowing
Height
- TurboMow mode has been activated.
- It is recommended to raise mowing height before
starting the mower in TurboMow mode. Refer to sections
3.1 and 4.3.7 in the User Manual.
49

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Robomow MS2500 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Robomow MS2500 in de taal/talen: Engels als bijlage per email.

De handleiding is 16,04 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Robomow MS2500

Robomow MS2500 Gebruiksaanwijzing - Nederlands - 64 pagina's

Robomow MS2500 Gebruiksaanwijzing - Deutsch - 62 pagina's

Robomow MS2500 Gebruiksaanwijzing - Français - 62 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info