●Selectthefunction name
and return to the Linkage
menu by touching the
RTN button.
<SensorTouch™>
SWASH RING
Swash ring setting procedure
1. Activate the function:
Move the cursor to the [ACT] item and touch
the RTN button to switch to the data input
mode.
Select the ACT mode by scrolling the touch
sensor.
*The display blinks.
Tou ch the RTN butt on to activ ate the
function and return to the cursor mode.
2. Rate setting:
Move the cursor to the [RATE] item touch the
RTN button to switch to the data input mode.
Set the rate by scrolling the touch sensor.
Initialvalue:100%.
Adjustmentrange:50to200%.
*Adjust the rate to maximum swash tilt.
*When the RTN button is touched for one second, the rate is
reset to the initial value.
Touch the RTN button to end adjustment and
return to the cursor mode.
Limitstheswashplatetraveltowithinaxedrange.(Helicopteronly)
This function limits the swash travel to a fixed
range in order to prevent damaging the swash
linkage by simultaneous operation of the ailerons
and elevators. It is very useful in 3D aerobatics
which use a large travel.
● Theoperatingrangedisplayarea:
The vertical direction shows the
elevat o r tr a v el. T he h o r izontal
direction shows the aileron travel.
● The marker shows the
stick position.
●Select[SWASHRING]intheLinkage
menu and access the setup screen
shown below by touching the RTN
button.
●Whentheswashringfunctionisactivated,
a circle is displayed in the operating
range display area and the rate input box
is displayed. Stick operation is limited to
the area of this circle.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
