115
In-fl ight needle control: see
THROTTLE-NEEDLE
.
INH
: makes a feature inactive/unable to be used. When a function is inhibited, it cannot be used even if the assigned switch
is ON. Turns off functionality without losing any settings. Only visible in specifi c features.
Inhibit: see
INH
.
Installation: radio installation and setup. ............................................................................................................................. 18
Inverted: to fl y a model upside-down.
Inverted fl ight control programming: not available in the 9C. Most modelers no longer use this icrutchi to fl y inverted,
instead learning to recognize the modelis behaviors when inverted and compensate appropriately.
Kill switch: (1) throttle cut switch to close carburetor (see
THR-CUT
, p. 40). (2) gasoline ignition engine kill switch which
removes spark to the plugs to stop the engine. .................................................................................................................... 74
Launch setting: (
GLID
) see
START-OFS
.
Linear Mix: a mix that maintains the same relationship of master to slave throughout the whole range. Ex: a mix from
one fl ap servo to another fl ap servo at 100% causes the 2nd servo to follow the fi rst servo’s movement exactly through all
points of travel. See Programmable mix.
LINK
: mixing function that allows multiple mixes to work in conjunction. See Programmable mix.
Lithium battery: see Backup battery.
Linear
: linear, directly proportional. See
AIRBRAKE
.
Low Band: 72MHz equipment on a channel from 11 to 35. Receiver channel may be changed to any channel within the
low band without needing retuning. ....................................................................................................................................... 8
LOGIC SW
: can be assigned to the following functions:
THR-CUT
,
IDLE DOWN
,
AUX-CH
,
TIMER
,
PROG. MIX
,
AIRBRAKE
,
ELEV-
FLAP
, and
AILE-FLAP
functions. The logic switch can activate functions by two switches combination. The 2 types of logic,
either AND or OR, can be selected. ..................................................................................................................................... 38
LOW BATTERY
warning: transmitter’s battery is below a safe fl ight voltage. Recharge immediately. See Error messages.
Low rate: see
D/R
,
EXP
.
MANUAL
: controlled by a switch. Ex: see
AIRBRAKE
.
Master: the primary control. See Programmable mix.
Mechanical gyro: uses a mechanical gyroscope (like a child’s toy gyro) to sense change of angle. See Gyros and
Governors.
MEMORY MODULE INITIALIZE
: warning to indicate that the CAMPac installed in the port is not yet formatted or formatted for
a dif
ferent model of transmitter. Pressing the Dial initializes the CAMPac, deleting any existing data and formatting the
CAMPac for use in the 10C. See Error codes.
MHz: Megahertz. Unit used to express frequency. 72MHz channels are aircraft only frequencies; 75MHz are ground model
only frequencies; 27MHz are air and ground both. 50MHz is legal for HAM amateur license holders. See Frequency.
Mix, mixing rate, mix offset, mix links: See Programmable mix.
MIXER ALERT
warning: notifi es user that a mix is activated which is not considered desirable for engine startup. See Error
messages.
Mode: defi nition of which channels are assigned to which STICK movements. All 10C radios shipped in the US are Mode 2,
with elevator and aileron on the right STICK. To change mode, please visit www.futaba-rc.com.
MODE BUTTON: control button on radio’s face used in various parts of programming. ................................................. 11
MODEL
COPY
: used to duplicate the settings of one model already in memory into a second model memory. Often used to
