780476
22
Verklein
Vergroot
Pagina terug
1/42
Pagina verder
22
(4) Put the chain on top of the smallest freewheel sprocket. Then,
insert the wheel into the frame dropouts and pull it all the way in to
the dropouts (Fig. 14).
(5) Tighten the adjusting nut until it is tight against the frame dropout;
then rotate the lever toward the front of the bike until it is parallel to
the frame's chainstay or seatstay tube and is curved toward the
wheel (Fig. 14).
CAUTION: If you can fully close the quick release without wrapping
your fingers around the chainstay/seatstay tube for leverage, and the
lever does not leave a clear imprint in the palm of your hand, the
tension is insufficient. Open the lever, turn the tension adjusting nut
clockwise a quarter turn, and then try again.
(6) If the lever cannot be pushed all the way to a position parallel to
the chainstay or seatstay tube, return the lever to the OPEN position.
Then turn the adjusting nut counterclockwise one-quarter turn and try
tightening again.
(7) Push the rear derailleur back into position.
(8) Close the brake shoes; then spin the wheel to make sure that it is
centered in the frame and clears the brake shoes.
6.1.4. Removing and Installing Bolt-On Wheels
6.1.4.a. Removing a Bolt-On Front Wheel
(1) Open up the brake
(2) With a 15mm box wrench or a six-inch adjustable wrench, loosen
the two axle nuts.
(3) If your front fork has a clip-on
type secondary retention device,
disengage it and go to step (4). If
your front fork has an integral
secondary retention device, loosen
the axle nuts about six full turns;
then go to step (4).
(4)Raise the front wheel a few inches off the ground and tap the top
of the wheel with the palm of your hand to knock the wheel out of the
fork ends.
6.1.4.b. Installing a Bolt-On Front Wheel
(1) With the steering fork facing forward, insert the wheel between
the fork blades so that the axle seats firmly at the top of the slots that
are at the tips of the fork blades. The axle nut washers should be on
the outside, between the fork blade and the axle nut. If your bike has
a clip-on type secondary retention device, engage it.
22

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Ridley Mountain Bike bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Ridley Mountain Bike in de taal/talen: Engels als bijlage per email.

De handleiding is 1.64 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info