780476
21
Verklein
Vergroot
Pagina terug
1/42
Pagina verder
21
6.1.3.b. Installing a Quick Release Front Wheel
(1) Rotate the quick-release lever so that it curves away from the
wheel (Fig. 11 & 13). This is the OPEN position.
(2) With the steering fork facing forward, insert the wheel between
the fork blades so that the axle sits firmly at the top of the slots that
are at the tips of the fork blades - the fork dropouts. The quick
release lever should be on the left side of the bicycle (Fig. 12 & 13).
If your bike has a clip-on type secondary retention device, engage it.
(3) Holding the quick-release lever in the OPEN position with your
right hand, tighten the tension adjusting nut with your left hand until it
is finger tight against the fork dropout (Fig. 11).
(4) While pushing the wheel firmly to the top of the slots in the fork
dropouts, and at the same time centering the wheel rim in the fork,
rotate the quick-release lever upwards and push it into the CLOSED
position (Fig. 11 & 12). The lever should be parallel to the fork blade
and curved towards the wheel.
CAUTION: If you can fully close the quick release without wrapping
your fingers around the fork blade for leverage, and the lever does
not leave a clear imprint in the palm of your hand, the tension is
insufficient. Open the lever; turn the tension adjusting nut clockwise a
quarter turn; then try again.
(5) If the lever cannot be pushed all the way to a position parallel to
the fork blade, return the lever to the OPEN position. Then turn the
tension adjusting nut counterclockwise one-quarter turn and try
tightening the lever again.
(6) Close the brake shoes; then spin the wheel to make sure that it is
centered in the frame and clears the brake shoes.
WARNING: Secondary retention devices are not a substitute for
correct quick release adjustment. Failure to properly adjust the quick
release mechanism can cause the wheel to wobble or disengage,
which could cause you to lose control and fall, resulting in serious
injury or death.
6.1.3.c. Removing a Quick Release Rear Wheel
(1) Open up the brake shoes (see Section 6.3.1, Figs. 16a, b, c and
d).
(2) Shift the rear derailleur to a high gear (the smallest, outermost
rear sprocket) and pull the derailleur body back with your right hand.
(3) Rotate the quick-release lever to the OPEN position (Fig. 11 &
13).
(4) Lift the rear wheel off the ground a few inches and, with the
derailleur still pulled back, push the wheel forward and down until it
comes out of the rear dropouts.
6.1.3.d. Installing a Quick Release Rear Wheel
(1) Shift the rear derailleur to its outermost position.
(2) Pull the derailleur body back with
your right hand.
(3) Rotate the quick-release lever to
the OPEN position. The lever should
be on the side of the wheel opposite
the derailleur and freewheel
sprockets.
21

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Ridley Mountain Bike bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Ridley Mountain Bike in de taal/talen: Engels als bijlage per email.

De handleiding is 1.64 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info