Assembling the safety net
Assembly
Step 1:
First lay the safety net (14) flat on top
of the trampoline. Be sure that the
entranceway to the safety net is
not above the support legs. The
entranceway should be over the
notice signs on the trampoline.
Step 2:
Insert the two support tubes (10 and
11), one into the other. Be sure
that a foam sheath (20, 21) is
located over each unit.
Step 3:
Insert the support tubes (10, 11)
sequentially into the sleeves provided
for them in the safety net (14).
Step 4:
Place the support tubes (10, 11) of the
safety net next to the support legs of
the trampoline.
Step 5:
Fasten the support tubes (10, 11) each
with 2 screws (12), 2 spacers (15), 2
washers (17) and 2 nuts (13) at the
holes in the support legs.
Step 6:
Secure the safety net (14) by
inserting the hooks attached
to the safety net into the loops
of the bounce mat. Once again check
all attachments and hooks, tightening
them where needed so the safety net is
firm. Now the assembly is completed.
(11) (10)
1
(10, 11)
4
(14)
(10)
(11)
3
6
2
Be sure that the entranceway is
unblocked and there is no tensi-
on on the zipper.
Step 7:
On the lower side of the sleeves of the
safety net there are two bands. Tie both
of these bands around the lower sup-
port tube (11). This will prevent the foam
sheaths (20/21) from slipping off.
Step 8:
To make for a convenient entry to the
device, the trampoline safety net is pro-
vided with an entry opening. When
entering, please open the three plastic
press locks on the left side of the entry
opening in the safety net. Then pull the
zipper and open the net.
After entering the device, the zipper
must be closed by the supervisor or
trainer, and it must be additionally
secured by latching the three plastic
press locks.
The device may only be used
when the entry opening is closed
and secured so as to minimize
the danger of accidents.
5
(12)
(13)
(15)
(17)
(10, 11)
(5)
(10, 11)
(5)
(12)
Trampoline
