POWEG63773X EN
Copyright © 2022 VARO P a g e | 15 www.varo.com
12.6 To clean air filter (Fig. 17)
NOTICE: Operating the engine without an air cleaner, or with a damaged air
cleaner, will allow dirt to enter the engine, causing rapid engine wear.
▪ Press down on the cover tab and remove the cover.
▪ Remove the filter from the air cleaner base..
▪ Inspect the filter and foam element, and replace it if damaged.
▪ Clean the filter by tapping it several times on a hard surface to remove dirt, or blow
compressed air through the air filter from the inside. Never try to brush off dirt; brushing
will force dirt into the fibers.
▪ Wipe dirt from the inside of the air cleaner base and cover, using a moist rag. Be careful to
prevent dirt from entering the air duct that leads to the carburetor.
▪ Reinstall the filter and cover.
12.7 Cable Adjustment
Before the machine is being used, the cable adjustment should always be checked.
The cables can be checked by activating the handles fully and check if the cable is tight. If not,
it must be tightened. If the handle cannot easily be fully activated, the cable should be
loosened.
After first season, it must be expected that the cables need to be adjusted for optimal
activation, as cables can stretch when used. To avoid damage it is recommended to have the
cables adjusted in a recognized service center.
The following cables may be necessary to readjust:
▪ Cable for drive (Fig. 18A)
▪ Cable for engine brake (Fig. 18B)
▪ Cable for throttle cable (Fig. 18C)
12.8 Maintenance schedule
Inspect and maintain this product regularly based on below maintenance table.
