POWEG63773X EN
Copyright © 2022 VARO P a g e | 13 www.varo.com
The replacement of the cutting device should be done by a qualified
specialist! Rework or sharpening blades is not recommended unless it is
done by a repair service or a similarly qualified specialist!
▪ Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition.
Regular maintenance is essential for safety and performance.
▪ Never store the equipment with fuel in the tank inside a building where fumes can reach
an open flame, a spark or a source of extreme heat.
▪ Allow the engine to cool before storing in any enclosure.
▪ To reduce the fire hazard, keep the engine; exhaust silencer, battery compartment and
petrol storage area free of grass, leaves, or excessive grease. Do not leave containers
with grass cuttings in doors.
▪ Replace worn or damaged parts for safety. For reasons of safety, do not use the
equipment with worn or damaged parts. Parts are to be replaced and not repaired. Parts
that are not of the same quality can damage the equipment and be dangerous for your
safety.
▪ If the fuel tank has to be drained, this should be done outdoors and when the engine is
cool.
▪ Check the self-closing guard and grass-catcher frequently for wear and deterioration.
▪ Whenever the machine is to be handled, transported or tilted you must:
o wear strong working gloves
o grasp the machine at the points that offer a safe grip, taking account of
the weight and its distribution.
12.1 Blade
12.1.1 Inspection
▪ Tilt the mower to the right, so the air cleaner side is up. This will help to prevent fuel
leakage and hard starting.
▪ Inspect the blade (21) for damage, cracks and excessive rust or corrosion.
▪ A dull blade (21) can be sharpened, but a blade that is excessively worn, bent, cracked, or
otherwise damaged must be replaced.
▪ A torque wrench must always be used when installing the blade (21).
▪ Check that the blade bolts are tight.
12.1.2 Removal and installation
If you remove the blade (21) for sharpening or replacement, you will need a torque wrench for
installation. Wear heavy gloves to protect your hands.
▪ Remove the bolt with a socket wrench. Use a wooden block to prevent the blade from
turning when removing the bolt. Then remove the blade.
▪ Install the blade using the blade bolt and special washers. Be sure to install the special
washers with the concave side toward the blade and the convex side toward the bolt.
▪ Tighten the blade bolt with a torque wrench. Use a wooden block to prevent the blade
from turning when tightening the bolt.
12.2 Grass Bag Cleaning and Replacement
12.2.1 Cleaning
Wash the bag (5) with a garden hose, and allow it to dry completely before use; a wet bag will
clog quickly.
