POWEG63732 EN
Copyright © 2022 VARO P a g e | 13 www.varo.com
▪ Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition.
Regular maintenance is essential for safety and performance.
▪ Never store the equipment with fuel in the tank inside a building where fumes can reach
an open flame, a spark or a source of extreme heat.
▪ Allow the engine to cool before storing in any enclosure.
▪ To reduce the fire hazard, keep the engine; exhaust silencer, battery compartment and
petrol storage area free of grass, leaves, or excessive grease. Do not leave containers
with grass cuttings in doors.
▪ Replace worn or damaged parts for safety. For reasons of safety, do not use the
equipment with worn or damaged parts. Parts are to be replaced and not repaired. Parts
that are not of the same quality can damage the equipment and be dangerous for your
safety.
▪ If the fuel tank has to be drained, this should be done outdoors and when the engine is
cool.
▪ Check the self-closing guard and grass-catcher frequently for wear and deterioration.
▪ Whenever the machine is to be handled, transported or tilted you must:
wear strong working gloves;
grasp the machine at the points that offer a safe grip, taking account of the weight and its
distribution.
11.1 Changing / draining the oil
The oil drain plug is located under the dipstick, at the base of the engine.
Have a container ready to catch the oil and remove the drain plug.
Once the oil has been emptied, replace the drain plug.
Make sure that the washer is in place and wipe any spillages.
Start the engine and allow it to run briefly. Stop the engine, wait one minute and check the oil
level. Top up if necessary.
11.2 Draining the fuel tank
▪ Empty the fuel tank when storing the product over 30 days to prevent the fuel
deteriorating.
▪ Unscrew and remove the fuel tank cap and use a proper fuel pump to empty the fuel into a
suitable container.
11.3 Spark plug
Allow the engine to cool down.
Remove the spark plug using the box spanner supplied; clean the plug with a wire brush. Set
the gap to 0.75 mm (0.030") using a feeler gauge.
Refit the spark plug taking care not to overtighten it.
Use only correct type spark plug. For best results, replace the spark plug every 100 hours of
use.
11.4 To clean air filter (Fig. H)
▪ Turn left to open cap of the air filter.
▪ Clean the air filter with an air compressor or warm water and liquid degreasing soap.
▪ Replace the air filter when it is no longer possible to clean it sufficiently.
▪ Rinse and dry the air filter in case of water cleansing.
▪ Fit the 3 tabs on the bottom of the the cap in the corresponding holes of the filter housing.
▪ Align cap three tabs with base. Press down and turn right to secure.
11.5 Cleaning the mower housing
Dirt deposits make the start difficult; affect the quality of the cut and the discharge of the grass.
Dirt and grass residues are easiest to remove immediately after the mowing. To avoid fouling
the floor, the underside must be cleaned on the grass.
