POWEG63732 EN
Copyright © 2022 VARO P a g e | 8 www.varo.com
▪ Improper maintenance, use of non-conforming replacement components, or the removal
or modification of safety components can damage the lawnmower and injure the operators
seriously.
▪ Only use the recommended blades and spare parts by the manufacturer. The use of non-
genuine parts can damage the machine and injure the operators. Keep the lawnmower in
good working condition.
▪ If the blade stopping device doesn’t work, please contact service centre for help.
Warning: Do not touch rotating blade.
Warning: Refuel in a well ventilated area with the engine stopped.
6 SAFETY WARNINGS
▪ Operate the lawn mower only with the grass box and/or the deflector plate installed.
▪ Stop the engine before emptying the grass box or adjusting the cutting height.
▪ Keep your hands and feet away from the area under the lawn mower or under the grass
discharge, while the engine is running.
▪ Before mowing, clear the lawn of any foreign objects which could be thrown up by the
lawn mower.
▪ Keep children, other persons and pets at a safe distance, while operating the lawn mower.
▪ Never tilt the lawn mower while starting it.
7 SAFETY WARNINGS GASOLINE
WARNING: Use extra care in handling fuels. They are flammable and the
vapours are explosive. The following points must be observed.
▪ Use only an approved container.
▪ Never remove the fuel cap or add fuel with the power source running. Allow engine
exhaust components to cool before refuelling.
▪ Do not smoke.
▪ Never refuel the machine indoors.
▪ Never store the machine or fuel containers inside, where is an open flame, such as a
water heater.
▪ If fuel is spilled, do not attempt to start the power source, but move the machine away
from the area of spillage before starting.
▪ Always replace and securely tighten the fuel cap after refuelling.
▪ If the tank is drained, this should be done outdoors.
8 ASSEMBLY
8.1 Assembling the handlebar (Fig. A, B & C)
▪ Slide both the lower handlebar (1) ends into the handlebar mounting holes (3) on the
mower body.
▪ Fasten with a screw in each handlebar mounting hole (3).
▪ Unfold the upper handlebar (2) and fasten it by using the locking knob (4) and the bolt on
the left side only.
▪ Next insert the second bolt in the right side hole of the handlebar (2).
▪ Slide the starter cable eye (a) over the bolt.
▪ Position the cable eye (a) pointing upwards to avoid contact between the starter cable ( 5)
and the lower handlebar.
