10
11
12
How to use the appliance
Note: the appliance will only function if
• The screw cap (S) or the blender (T-X)
have been properly mounted onto the
motor unit (A) and
• The bowl (B) and the accessories (lid (C),
citrus press or juice extractor) have been
placed on the motor unit in accordance
with the instructions in this booklet.
• If both the blender and the bowl have been
mounted correctly onto the motor unit, only
the blender will function.
Set the speed control (P) to the position
indicated in the tables on pages 13-15 and
switch the appliance on. When you have
doubts about the right speed, always select
the highest speed (setting 5).
Blade (G) £
Be careful: the cutting edges of the blade
are very sharp!
• The blade can be used for chopping,
mixing, blending, pureeing and preparing
puff pastry, crumble and shortcrust pastry.
- Remove the protective cover from the
blade (fig. 10).
- Put the bowl on the motor unit (fig. 2) and
fit the blade onto the driving shaft (fig. 11).
- Put the ingredients in the bowl (fig. 12).
- Fasten the lid onto the bowl and put the
pusher in the chute.
- Set the speed control (P) to the position
indicated in the table and switch the
appliance on. If you have doubts about the
correct speed, always select the highest
speed (position 5).
- Applications/recipes mentioned in the table
will be ready after 10-60 seconds.
Tips:
• It is better not to chop large chunks with
the blade; pre-cut them into pieces of
approximately 3 cm before putting them in
the food processor.
• The appliance chops very quickly; let it run
for short periods at a time, also when you
are using the pulse setting (M), to prevent
the food from becoming too finely chopped.
• Do not let the appliance run for too long
when you are chopping (hard) cheese; the
cheese will get too hot and will start to melt
and become lumpy.
• If food sticks to the blade or to the inside of
the bowl:
- turn the appliance off;
- remove the lid from the bowl;
- remove the ingredients from the blade or
the inside of the bowl with a spatula.
• Do not chop very hard ingredients like
coffee beans, nutmeg and ice cubes. They
could cause the blade to get blunt. Check
the table for the appropriate speed and
setting.
6
