& Connect two Surround Sound rear loudspeakers (either
supplied or not according to the type of TV set purchased)
to the connector clips at the back of the TV. Always connect
both Surround Sound loudspeakers: the left rear loudspeaker
at
REAR L; the right rear loudspeaker at REAR R.
Push the connector clip down and insert the end of the wire into
the opening: the positive wire (the one with the black line) to the
red loudspeaker connection; the negative wire to the black
loudspeaker connection. Do not insert the wires too far.
The Surround Sound loudspeakers should always be located
behind and to either side of the listener. If preferred you can also
hang the loudspeakers on the wall.
é Select Rear speakers Yes in the Setup menu (available
according to the type of TV set). See p. 13.
See Surround settings, p. 20 for the available Surround
modes.
Rear Surround Sound loudspeakers should always be located
behind or to either side of the listener at about 1 m above
the seated listener’s head.
“ Adjust the volume of the rear loudspeakers.
You can use the Test tone function in the Surround settings
menu, see p. 20, as a reference to set the volume level of the
separate loudspeakers.
Note: Once you have adjusted the volume of the rear
loudspeakers, do not change it while watching TV, the volume
level of all the speakers is changed with the volume control of
the TV.
& Connect two rear loudspeakers (not supplied) with built in
amplifiers (or an audio amplifier with rear loudspeakers).
Connect the audio cables to the rear loudspeakers and to
the Dolby surround output
S at the back of your TV as
shown above.
There is only one cinch output for both speakers. Use a
mono to stereo adaptor.
Note: Switch off the TV and the rear loudspeakers before
connecting them.
é Select Rear speakers Yes in the Setup menu (available
according to the type of TV set). See p. 13.
See Surround settings, p. 20 for the available Surround
modes.
Rear Surround Sound loudspeakers should always be located
behind or to either side of the listener at about 1 m above
the seated listener’s head.
“ Adjust the volume of the rear loudspeakers.
You can use the Test tone function in the Surround settings
menu, see p. 20, as a reference to set the volume level of the
separate loudspeakers.
Note: Once you have adjusted the volume of the rear
loudspeakers, do not change it while watching TV, the volume
level of all the speakers is changed with the volume control of
the TV.
REAR multimedia loudspeakers
You can enjoy Dolby Pro Logic Surround sound by connecting two rear
loudspeakers (either supplied or not according to the type of TV set) to be
connected or to the connector clips (if provided) or to the Dolby Surround
output
S at the back of your TV.
Connect Extra loudspeakers / Amplifier
