SETUP
Digital Sources
Decoder/Descrambler
(Picture tilt)
Information line
Factory settings
Extra front speakers
(Rear speakers)
Auto Surround
Auto format yes/no
INSTALLATION
J Digital sources
& Insert the plug into the headphone socket L at the right side of the TV.
é Press ¬ on the remote control to switch off the internal loudspeakers
of the TV.
The headphone impedance must be between 8 and 4000 Ohm.
The headphone socket has a 3.5 mm jack.
In the SOUND menu select Headphone volume to adjust the headphone
volume. See p. 18.
Headphone
Connect your digital equipment with a eurocable 1 to one of the
euroconnectors (
EXT1 or EXT3), or with a cinch cable to the VIDEO input
at the right side of the TV (see illustration above).
& Press h and X at the same time.
é Select Digital sources in the Setup menu of the INSTALLATION menu and
select:
•
None if you have no digital source connected,
•
EXT1 or EXT3 if you have connected your equipment to a euroconnector,
•
FRONT in case you connected your equipment to the right side of the TV.
“ Press the SETTINGS key to switch off all menus.
Note: the low quality of some digital picture material may be the cause of digital
image distortion. In this case select
Soft under the SMART PICTURE a key on the
remote control as this setting is intended to improve distorted picture quality.
Digital equipment (DVD, digital satellite tuner,...)
& Connect your camera or camcorder to sockets at the right side of your TV.
é Connect the equipment to VIDEO 2 and AUDIO L 3 for mono
equipment.
Press the
X key repeatedly to select the sound coming from one or
both loudspeakers of your TV.
“ For stereo equipment also connect AUDIO R 3.
S-VHS quality with an S-VHS camcorder is obtained by connecting the S-VHS
cables with the S-VIDEO input 1 and AUDIO inputs 3.
Camera & camcorder
