478161
36
Verklein
Vergroot
Pagina terug
1/44
Pagina verder
A
B
Stitches & sewing techniques36
Chainstitch sewing
The chainstitch is sewn with two threads, one needle and one looper. Normally, the machine trims the fabric edge
while the seam is being sewn. However, a chainstitch seam can be placed at a desired distance from edge of fabric by
putting the upper cutter in B position, disengaging the upper looper and installing coverstitch table B. (See page 10-11)
Turn off the main power switch and unplug the machine.
Machine set up
Disengage the movable upper cutter. (See page 10)
Disengage the upper looper. (See page 11)
Remove cutter cover A and install coverstitch table B (see page 11). The graduations on the coverstitch table indicate
the distance, in cm and inches, from coverstitch middle needle. Use it as a guide when positioning the fabric edge.
Start and end of sewing
When starting to sew after threading the machine, sew 2-3 cm on a scrap fabric and chain off to make a chain. At end of
sewing, pull the fabric lightly to the rear of machine and chain off.
Sewing hints
Pintuck sewing
Sew decorative pintucks on the fabric before cutting
out the garment. Use overlock right needle and select
3-thread overlock, narrow.
Note: The rolled edge stitch can also be used for this technique.
Disengage the movable upper cutter. (See page 10)
Mark the fabric with the desired number of pintucks
using a water-soluble fabric marker.
Fold the fabric with the wrong sides together and sew.
Press the pintucks in the same direction.
Sew in Circles
(only suitable for heavy and medium weight fabrics)
The extension table has 13 holes in it, used to sew in
circles.
Sew circles with the movable upper cutter engaged (A
position, see page 10) to get a beautiful edge, or disengage
the movable upper cutter (B position, see page 10) and
sew circle embellishments.
Mark a dot in the center of the area that will be the
circle and place stabilizer under the fabric.
Pierce the fabric at the mark with the sharp
end of the push pin (A). Place the pin into
the selected hole on the extension table. Push
the pin and its bottom plate (B) together.
Lower the presser foot and sew. The fabric
will feed in a circle around the push pin.
When the circle is complete, overlap the seam for a few
centimetres (an inch). Thread the threads into a large
eyed, hand sewing needle and pull them to the wrong
side of the fabric and secure.
Securing the thread chain
Thread the chain into a large eyed, hand sewing needle.
Insert the needle into the end of the seam and pull the
chain into the seam to secure the threads.
Braiding by chaining off
1. Disengage the movable upper cutter. (See page 10)
2. Insert À ller cord such as yarn or twill tape through the
hole in the front of the foot.
3. Position the À ller cord under the foot and chain off the
desired length.
4. Chained off braids can be used individually or woven
into 3 or 4 ply braids.
Lowering the needle(s)
When you stop sewing, the machine always stops with
the needle(s) in the up position. Tap the foot control one
time to lower the needle(s) into the fabric. The needle
down position is useful to hold your fabric in place when
making adjustments or when turning the fabric to change
direction when chainstitch sewing.
36

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Pfaff-Coverlock-4.0

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Pfaff Coverlock 4.0 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Pfaff Coverlock 4.0 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,3 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Pfaff Coverlock 4.0

Pfaff Coverlock 4.0 Gebruiksaanwijzing - Nederlands - 44 pagina's

Pfaff Coverlock 4.0 Gebruiksaanwijzing - Deutsch - 44 pagina's

Pfaff Coverlock 4.0 Gebruiksaanwijzing - Français - 44 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info