15
chamber (6) firmly.
15 The appliance is ready for brewing when the display
illuminates green. Then push the start button .
24 After brewing, empty the powder holder. The
paper filter is also degradable just like the coffee
powder.
25 26 The powder holder and the pod holder have
to be rinsed after each brewing process.
Check regularly whether the opening in the midd-
le of the pod holder (7) is free of coffee remains.
Changing coffee quantity
The coffee quantity in one pod and in the powder hol-
der respectively is optimal for one cup. You can vary
the filling amount per cup according to your personal
taste by changing the intensity of the coffee.
The Coffeemaker for Soft Pods gives the comfortable
possibility to programm the individual coffee amount
desired for each start button or :
1. Insert the pod as described above, push the swivel
lever (5) into the area of „Brewing“ to the left-
hand side as far as it will go and wait until the dis-
play illuminates green, i.e. the appliance is
ready for brewing.
2.Push the programmable start button or
as long (3 to 4 seconds) until the display flashes
green. While brewing, the programming mode is
active. Observe the filling process of the cup. When
the quantity desired is reached, push the same start
button again. The brewing stops and the brewing
time (power-on-time of the pump) is programmed.
When pushing this start button, you always have
the same brewing time. The coffee quantity prepa-
red will only differ slightly - according to the coffee
quantity.
Advice for the programming mode:
While brewing the programming mode is active for
max. 30 seconds and/or 60 seconds . If
you do not push the start button before brewing stops
automatically, the maximal filling amount is program-
med.
Recovering standard quantity
In order to achieve the original filling amount, please
proceed as follows:
1. Switch off the appliance.
2. Push the start button as long (3 to 4 seconds)
as both displays and flash up twice shortly.
Preparation of hot water
For the preparation of tea or instant drinks you can
take the water with an optimum temperature from the
hot water outlet (20).
17 Put a tea or coffee cup with a maximum height of
9.5 cm under the hot water outlet (20) on the drip tray
(9).
Wait until the display illuminates green, i.e. the
appliance is ready for brewing.
6 Place the swivel lever (5) over the symbol „Hot
water“ .
17 According to the size of the drinking cup press
the required start button or .
When pressing the same start button or
the quantity of the hot water might vary con-
siderably from the usual coffee quantity.
Therefore, please observe the filling process. You
can stop at any time by pushing the corresponding
start button or
again
.
Before removing the cup, push the swivel lever (5)
into the starting position . This reduces the dripping
time from the hot water outlet (20).
It is of course also possible to programm the hot
water quantity as described in section “Changing
coffee quantity”.
Disconnection
The appliance can be switched off at any time by
pushing the ON/OFF button . If the appliance
remains switched on, it switches off automatically 60
minutes after the last usage. Afterwards, the power
consumption is less than 2 Watt.
Level indicator
The fresh water level is constantly controlled by a
float in the water container (3). If the required mini-
mum filling amount is under-run, the display flashes
red. As soon as you top up the filled water container
(3), the operation continues.
Descaling
The appliance must be descaled regularly, as
every hot-water appliance. For this purpose use the
special de-scaling agent durgol
®
swiss espresso
®
which is available in selected specialist retailers. If
you wait too long before descaling, the appliance
might get damaged. The follo-wing indications are gui-
delines. When the crema of the coffee is no longer
