Problem Remedy
The quality of the cre-
ma is unsatisfactory.
With new appliances, the optimum crema quality will not be obtained •
until after the appliance has been in use for some time.
Clean and decalcify the filter insert at regular intervals.•
The filters in the filter insert must not be pressed together. If this •
happens, the insert must be replaced.
The coffee outlet
drips over a long
period after use.
After brewing always set the control knob back to home position •
to prevent prolonged dripping.
The appliance swit-
ches off when heating
up.
The appliance is not allowed to be operated in locations that are •
higher than 1,500 m above sea level.
The rinsing process
does not start.
It is important that both buttons are pressed simultaneously.•
The decalcification
programme does not
start
It is important that both buttons are pressed simultaneously. Try to •
activate the programme again and release the buttons only after the
decalcification indicator
comes on permanently and the pump is
running.
Water escapes at the
handle of the pad
cartridge.
Check that the pad is properly seated in the pad cartridge. If the •
paper edge of the pad projects over the edge of the recess, sealing
will be prevented during brewing.
Water may escape suddenly even when the pad cartridge is clogged.•
There is water under
the appliance.
Empty the drip pan in good time.•
Do not fill the water container higher than the • max mark.
Never leave the appliance to stand for long periods without the water •
container.
