Registering the camera
This procedure is not required for devices
t
hat were included as part of a bundle.
Before you can use the camera, it must be
r
egistered to the hub.
If the camera is not registered to a hub, the
camera’s LED indicator blinks slowly in amber.
You can register each device by using the
registration buttons or the [Home Network]
app.
Note:
R Before registering the camera, make sure
the AC adaptors of the hub and camera are
connected and each device is powered.
Using registration buttons
1 H
ub:
Press and hold M
CAMERAN until the
LED indicator blinks slowly in green.
2 Camera:
Using an object with a thin tip, press and
hold M N
until the LED indicator blinks
slowly in green (page 14).
R When registration is complete, the hub
sounds one long beep.
Note:
R T
o cancel without registering the camera,
press M
N
on the hub and on the camera
again.
R If registration fails, the hub sounds several
short beeps.
Using the app
W
hen you register the camera by using the
[Home Network] app, you can assign a name
to your devices and group them by location.
For more information, refer to the User’s
Guide (page 25).
Confirming the registration
a
rea
Before deciding where to install the camera,
carefully read the chapter “Installation
Location”, beginning on page 7, to confirm the
installation location and direction.
For assistance, please visit http://shop.panasonic.com/support
15
Setup
