51
50
ERROR MESSAGES
Error Meaning
MEM FULL
BATTERY LO
TOO LONG
LIST END
INVALID
NOT FOUND
ERROR
Maximum memory capacity
has been reached.
Replace batteries with four
new "AAA" Alkaline batteries.
Macro sequence being entered
exceeds 15 keystrokes.
You have reached the end of
all valid codes using the
Step-N-Set sequence.
Displayed when trying to
specify a key that is not valid
for the sequence being
entered. For example, when
selecting a Device Key (e.g.,
TV) for a Macro sequence.
Displayed when you enter in
a code that is not valid for the
device being programmed.
Displayed when an error has
occurred in the learning
sequence.
Consumer Help Line: 1-330-593-3325
World Wide Web: http://www.hudsonag.com
E-mail help: Help@hudsonag.com
TROUBLESHOOTING (cont.)
Problem: Solution
CH +/- and PREV
CH not working for
your RCA TV?
Problems changing
channels?
The red light blinks
when you press a
key but you receive
no response from
your home entertain-
ment component?
Your audio compo-
nents turn on and off
and control volume
but do not change
preset channels?
Your DSS satellite
receiver does not
respond to the
codes listed in the
manual?
The Home Producer
is not operating your
Bang & Olufsen
equipment?
Due to RCA design (1983-
1987), only the original
remote control will operate
these functions.
If your original remote control
required an ENTER keystroke
when changing channels,
press the ENTER key on the
Home Producer after you
enter the channel number.
Make sure you are aiming
your Home Producer at your
home entertainment compo-
nent and that you are within
15 feet before using your
remote control.
Some audio components may
need both a Tuner/Receiver
code and an Audio Amplifier
code to control all of the fea-
tures of your audio component.
The codes listed in this man-
ual are set up to operate your
DSS receiver on the 1st or
2nd addresses only. Make
sure the DSS Receiver can
be operated with an infrared
remote control and is not set
up to only receive Radio
Frequency.
Some Bang & Olufsen prod-
ucts, as well as some other
manufacturer’s equipment
operate at a frequency higher
than 100 kHz and will not
work with the Home Producer.