663190
10
Verklein
Vergroot
Pagina terug
1/15
Pagina verder
EN
EN
Install the NuVinci N360 CVP
into a vice or xture as shown,
clamping on the left hand axle ats.
fIf a vice is not available,
installation in the bicycle frame
is possible, tightening only the
left hand side no-turn washer
and axle nut to allow rotation
of the hub interface.
While driving the CVP clockwise
with the sprocket (1), rotate the
hub interface (2)
counter-clockwise
toward
the full overdrive (H) position
until a rm stop is felt. Repeat this
rotation 2-3 times by driving the
CVP clockwise and rotating the hub
interface back and forth, ending at
a rm stop toward (but likely not at)
the full overdrive (H) position.
fThe indicated position of the
hub interface is unimportant
in this step.
fWhen in full overdrive, the
hub/wheel should rotate
approximately 1.8-2 times
for every 1 rotation of the
CVP sprocket.
When full overdrive is found,
remove the hub interface per
Step 5.5.
Check to make sure the mark on
the spline nut and shift driver align
per Step 5.6.
Install hub interface per Steps 2.4
through 2.10.
At all times while rotating
the wheel, sprocket, or hub
interface, be careful not to
catch or pinch ngers.
5. SERVICE INSTRUCTIONS
Remove the rear wheel per Section 3.
Remove the hub interface per Step 5.5.
Reference the Exploded Diagram
on Page 22. Remove the sprocket
snap ring (12), sprocket spacer
(13, if installed), and sprocket (14).
Remove the snap ring (15) on
the shift driver, and remove the
freewheel assembly (16).
fIf servicing or replacing,
use a medium-weight oil or
lightweight water-resistant
grease and check function.
Remove the interior snap ring
(17), needle bearing (18), and RH
shield (19) if these components are
being replaced.
Install the serviced / new free-
wheel components according to
the Exploded Diagram on Page 22.
Install sprocket and hub interface
per Section 2.
Install the rear wheel per Section 3.
Servicing or Replacing
Freewheel
Set the NuVinci N360 CVP
in full overdrive with the front
shifter or hub interface prior to
removal.
5. SERVICE INSTRUCTIONS
17
18
5.8
5.9
5.10
5.11
17
18
19
16
15
5.10
5.11
5.8
5.9
1
2
fReference Exploded Diagram P.21
10

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw NuVinci N 360 - 2012 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van NuVinci N 360 - 2012 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,99 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van NuVinci N 360 - 2012

NuVinci N 360 - 2012 Gebruiksaanwijzing - Nederlands - 15 pagina's

NuVinci N 360 - 2012 Gebruiksaanwijzing - Deutsch - 15 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info