654079
93
Verklein
Vergroot
Pagina terug
1/107
Pagina verder
84
8. Appendix
Common Problems & Solutions (“Power/Status/LampIndicator”onpage83.)
Problem Check These Items
Does not turn on
• Checkthatthepowercableispluggedinandthatthepowerbuttonontheprojectorcabinetortheremotecontrolis
on� ( page 15, 16)
• Ensurethatthelampcoverisinstalledcorrectly.( page 81)
• Ensurethatthetwoscrewsonthelamphousingarecompletelytightened.( page 81)
• Ensurethatthecoolingpumpisinstalledcorrectly.( page 82)
• Checktoseeiftheprojectorhasoverheated.Ifthereisinsufcientventilationaroundtheprojectororiftheroom
where you are presenting is particularly warm, move the projector to a cooler location�
• Checktoseeifyoucontinuetousetheprojectorforanother100hoursafterthelamphasreachedtheendofitslife.
If so, replace the lamp�
Afterreplacingthelamp,resetthelamphoursused.( page 77)
• Thelampmayfailtolight.Waitafullminuteandthenturnonthepoweragain.
• Set[FANMODE]to[HIGHALTITUDE]whenusingtheprojectorataltitudesapproximately5000feet/1500meters
orhigher.Usingtheprojectorataltitudesapproximately5000feet/1500metersorhigherwithoutsettingto[HIGH
ALTITUDE]cancausetheprojectortooverheatandtheprojectorcouldshutdown.Ifthishappens,waitacouple
minutes and turn on the projector� ( page 71)
Alsowhenthelampisturnedoff,theprojectorinternaltemperatureishot.Ifthepoweristurnedonbeforethepro-
jector has cooled down, the fan will run a short time before the lamp will turn on�
Will turn off • Ensurethatthe[OFFTIMER]or[AUTOPOWEROFF]isoff.( page 72, 73)
• Checkiftheprojectorhasstayedwithitslenscoverclosedformorethan2hours.( page 5)
No picture
• Usetheappropriatesourcebuttonontheremotecontroltoselectyoursource.( page 18) If there is still no pic-
ture, press the button again�
• Ensureyourcablesareconnectedproperly.
• Usemenustoadjustthecontrastandbrightness.( page 59)
• Checktoseeiftheimageismuted.( page 30)
• Ensurethatthelenscoverisopen.( page 5)
• Resetthesettingsoradjustmentstofactorypresetlevelsusingthe[RESET]intheMenu.( page 77)
• EnteryourregisteredkeywordiftheSECURITYfunctionisenabled.( page 33)
• BesuretoconnecttheprojectorandnotebookPCwhiletheprojectorisinstandbymodeandbeforeturningonthe
powertothenotebookPC.
InmostcasestheoutputsignalfromthenotebookPCisnotturnedonunlessconnectedtotheprojectorbeforebe-
ing powered up�
* Ifthescreengoesblankwhileusingyourremotecontrol,itmaybetheresultofthecomputer’sscreen-saveror
power management software�
• Seealsothenextpage.
Picture suddenly be-
comesdark
• Whenoneofthefollowinghappens,the[ECOMODE]automaticallychangesfrom[OFF]to[ON].
* Whentherearenosignals(blueorblackscreen)Toreturntothe[OFF]mode,selectanotheravailablesource.
* Whentheroomwhereyou’representingisparticularlywarm Move the projector to a cooler location�
Imageisn’tsquaretothe
screen
• Repositiontheprojectortoimproveitsangletothescreen.( page 20, 21)
• UsetheKEYSTONEcorrectionfunctiontocorrectthetrapezoiddistortion.( page 25)
Picture is blurred
• Makesurethatfocusisappropriate.
• Repositiontheprojectortoimproveitsangletothescreen.( page 20, 21)
• Ensurethatthedistancebetweentheprojectorandscreeniswithintheadjustmentrangeofthelens.( page 10)
• MakesurethatthedistancebetweenthefocussensorandthescreeniswithintheeffectiverangeoftheAUTOFO-
CUS� ( page 22)
• MakesurethattherequirementsfortheAUTOFOCUSaremet.( page 22)
• Condensationmayformonthelensiftheprojectoriscold,broughtintoawarmplaceandisthenturnedon.Should
this happen, let the projector stand until there is no condensation on the lens�
Flicker appears on screen Set [FAN MODE] to other than [HIGH ALTITUDE] mode when using the projector at altitudes approximately 5000
feet/1500 meters or lower. Using the projector at altitudes less than approximately 5000 feet/1500 meters and setting
to [HIGH ALTITUDE] can cause the lamp to overcool, causing the image to icker. Switch [FAN MODE] to [AUTO].
(
page 71)
Image is scrolling verti-
cally, horizontally or both
• Usetheappropriatesourcebuttonontheremotecontroltoselectyoursource.( page 18)
• Adjustthecomputerimagemanuallywiththe[HORIZONTAL]and[VERTICAL]in[ADJUST][IMAGEOPTIONS]in
the menu� ( page 61)
Remote control does not
work
• Installnewbatteries.( page 8)
• Makesuretherearenoobstaclesbetweenyouandtheprojector.
• Standwithin22feet(7m)oftheprojector.( page 8)
Indicatorislitorblinking • SeethePOWER/STATUS/LAMPIndicator.( page 83)
CrosscolorinRGBmode • PresstheAUTOADJ.buttonontheremotecontrol( button on the projector cabinet)� ( page 27)
• Adjustthecomputerimagemanuallywith[CLOCK]and[PHASE]in[ADJUST][IMAGEOPTIONS]inthemenu.(
page 60)
Cannot control the pro-
jector in standby mode
from the PC Control�
• Checkif[STANDBYMODE]isnotsetto[POWER-SAVING].
The projector does not
operate correctly
• Turnoffthepowerandunplug thepowercable.Waitfor5minutes.Plugthepowercableandturnonthepower
again�
Formoreinformationcontactyourdealer.
93

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Nec NP43 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Nec NP43 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,36 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Nec NP43

Nec NP43 Gebruiksaanwijzing - Deutsch - 107 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info