654079
92
Verklein
Vergroot
Pagina terug
1/107
Pagina verder
83
8. Appendix
Troubleshooting
Thissectionhelpsyouresolveproblemsyoumayencounterwhilesettinguporusingtheprojector.
Indicator Messages
Power Indicator
Indicator Condition Projector Condition Note
Off The main power is off
Blinkinglight
Green
0.5secOn,
0.5secOff
The projector is getting ready to turn on� Wait for a moment�
2.5secOn,
0.5secOff
OffTimerisenabled.
Orange
0.5secOn,
0.5secOff
The projector is cooling down Wait for a moment�
Steady light
Green
The projector is turned on
Orange
[NO RM AL] is se le cte d fo r [S TA NDBY
MODE]
Status Indicator
Indicator Condition Projector Condition Note
Off
NormalorStandby([POWER-SAVING]for
[STANDBYMODE])
Blinkinglight
Red
1cycle(0.5secOn,2.5
secOff)
Lampcovererrororlamphousingerror Replace the lamp cover or lamp housing correctly�
2cycle(0.5secOn,0.5
secOff)
Temperature error
The projector is overheated Move the projector to a
cooler location�
3cycle(0.5secOn,0.5
secOff)
Power error
Power unit is not working properly.Contac tyour
dealer
4cycle(0.5secOn,0.5
secOff)
Fanerror Fanswillnotworkcorrectly.
6cycle(0.5secOn,0.5
secOff)
Lamperror
Lampfailstolight.Waitafullminuteandthenturnon
again�
8 cycle in red and 1
cycle in green (0�5 sec
On,0.5secOff)or
8 cycle in red and 2
cycle in green (0�5 sec
On,0.5secOff)
Cooling pump error
• The two screws on the lamp housing are notcom-
pletely tightened� Tighten the two screws alternately
until both screws are completely tightened�
• Thecooling pump is not working properly. Contact
your dealer�
Green
Re-firing the lamp (The projector is cooling
down�)
The projector is re-firing�
Wait for a moment�
Steady light
Green
Standby([NORMAL]for[STANDBYMODE])
Orange
CONTROLPANELLOCKison.
You have pressed cabinet button when Control Panel
Lockison.
CONTROLIDerror Remote control ID and projector ID are not matched�
Lamp Indicator
Indicator Condition Projector Condition Note
Off Normal
Blinkinglight Red
Lamp has reachedits endof life. Lamp re-
placement message will be displayed�
Replace the lamp�
Steady light
Red
Lamp hasbeen usedbeyond itslimit. The
projector will not turn on until the lamp is
replaced�
Replace the lamp�
Green [ECOMODE]issetto[ON]
Over-Temperature Protection
Ifthetemperatureinsidetheprojectorrisestoohigh,theover-temperatureprotectorwillautomaticallyturnoffthe
lampwiththeSTATUSindicatorblinking(2-cycleOnandOff.)
Shouldthishappen,dothefollowing:
-Unplugthepowercableafterthecoolingfansstop.
-Movetheprojectortoacoolerlocationiftheroomwhereyouarepresentingisparticularlytoowarm.
-Cleantheventilationholesiftheyarecloggedwithdust.
-Waitabout60minutesuntiltheinsideoftheprojectorbecomescoolenough.
92

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Nec NP43 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Nec NP43 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,36 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Nec NP43

Nec NP43 Gebruiksaanwijzing - Deutsch - 107 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info