CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS
No sound from all channels. AC power unplugged.
•
Check AC cable connection and outlet.
•
Power not switched on.
•
Outlet has no power.
•
Speaker A (or Speaker B) is not activated.
•
Activate Speaker A (or Speaker B) by pressing
the corresponding front panel or HTR 3
button.
•
No sound from some channels. Faulty/missing cables.
•
Check cables.
•
’Speaker Conguration’ channel (s) set to
“OFF”.
•
Check ‘Speaker Conguration’ menu.
•
Power-amp or speaker-connections faulty.
•
Check power amp, cabling, and speakers.
•
No sound from surround channels. No surround listening mode is engaged.
•
Select appropriate listening mode.
•
Surround-channels set to “OFF” on ‘Speaker
Conguration’ menu.
•
Correct ‘Speaker Conguration’ or ‘Speaker
Levels’ settings.
•
Surround-channels level set too low on
‘Speaker Levels’ menu.
•
No sound from Subwoofer. Subwoofer is o, not powered or improperly
connected.
•
Power-up subwoofer, check Sub’s AC outlet
or check connections.
•
Subwoofer set to “OFF” on ‘Speaker
Conguration’ menu.
•
Correct ‘Speaker Conguration’ or ’Speaker
Levels’ settings.
•
Sub level set too low on ‘Speaker Levels’
menu.
•
No sound from Center channel. Source is a 2/0 (etc.). Dolby Digital or DTS
recording without center channel.
•
Play a known 5.1-channel recording or select
Dolby Pro Logic IIx Music mode.
•
Center set to “OFF” on ‘Speaker Conguration’
menu.
•
Correct ‘Speaker Conguration’ or ‘Speaker
Levels’ settings.
•
Center level set too low on ‘Speaker Levels’
menu.
•
No Dolby Digital/DTS. Source’s digital output is not connected to a
T 765 digital input.
•
Check connections.
•
Source component not congured for
multichannel digital output.
•
Check source component setup.
•
T 765 does not respond to HTR 3 remote. Batteries are at or incorrectly inserted.
•
Check batteries.
•
IR transmitter window on remote or IR A/V
Receiver window on T 765 is obstructed.
•
Check IR windows and ensure clear line-of-sight
from remote to T 765.
•
T 765 front panel is in very bright sunlight or
ambient light.
•
Reduce sunlight/room lighting.
•
T 765 does not respond to front panel
commands or remote control.
Microprocessor error.
•
Power-down the T 765 via the rear panel
Power switch and unplug it from the AC
outlet.
•
T 765 may have over heated.
•
Wait ve minutes, re-connect and power up.
•
12V TRIGGER IN/OUT is set to AUTO position.
•
Switch 12V TRIGGER IN/OUT to OFF position.
•
Factory defaults for 120V version only : Press simultaneously Source + Front Input/MP
Factory defaults for 230V version only : Press simultaneously Source + Front Input/MP
Audyssey Setup settings along with other stored presets and settings will all be deleted upon restoring your T 765 to its factory defaults.