LOADING CODE-LIBRARIES
The HTR 3 can store a dierent library of default NAD codes for each of its Device Selector “pages.”
If the original default library does not control your NAD CD player, tape deck, DVD player, or other
component, follow the procedure below to change the code-library.
Begin by ensuring that the component you wish the HTR 3 to control is plugged in and powered-up
(“on,” not merely in standby). To enter the HTR 3s Library Mode, simultaneously press-and-hold for 3
seconds both the desired Device Selector key and the [AVPS] key, until the Learn LED turns green.
While keeping the HTR 3 pointed toward the component, enter the rst appropriate three-digit code-
library number from the table below. Press [OFF]. If the component turns o, press [ENTER] to accept
that code-library number and exit the Library Mode. If the component does not turn o, enter the next
three-digit code-library number from the table.
When you enter the correct number the component will turn o; press [ENTER] to accept that code
library number and exit the Library Mode.
LIBRARY CODE NAD PRODUCT DESCRIPTION LIBRARY CODE NAD PRODUCT DESCRIPTION
100 Receiver/Processor (Discrete ON/OFF) 300 Tuner
101 Receiver/Processor (Toggle ON/OFF) 301 L75, L76 Tuner
102 S170 302 L70 Tuner
103 L75 303 L53 Tuner
104 Second Zone Commands (Zone 2) 304 L73 Tuner
3112 Zone 3 305 C425
4112 Zone 4 306 C445
105 L70 307 Txx5 Series Tuner
106 L76 400 Tape Deck B
107 118 401 TAPE Deck A
108 L53 500 TV 280
109 L73 501 MR13
110 Stereo Receiver / Amplier 502 MR20
111 Stereo Second Zone 503 PMR45
112 Txx5 Series 600 T535, T562, T585, M55
200 CD Player 601 T550, L55
201 CD Player (old) 602 T512, T531, T532, T571, T572
202 5170, 5240, 5340 603 L70, L73 DVD
203 5325 604 L56
204 5060 605
T513, T514, T515, T517, T524, T533, T534
205 M5 606 L53 DVD
SEARCH MODE
If none of the codes from the table, when entered, turns on the component, and if you are quite sure
you have followed the above procedure completely and carefully, you may want to try the “search”
method as follows:
Enter Library Mode by simultaneously pressing-and-holding for 3 seconds both the desired Device
Selector key and the [AVPS] key, until the Learn LED turns green. Now press-and-hold the HTR 3’s [ ] or
[ ]) key; the remote will step through all the available codes at a rate of approximately 1 per second.
When the component turns o, immediately release the cursor key; press [ENTER] to accept that code-
library and exit the Library Mode. Try a few commands; should you prove to have stepped past the
needed code-library, re-enter the Library Mode and use the cursor key to step back to it.
NOTE
It is possible that search mode will nd code-libraries that operate, at least partially, some other
brand (non-NAD) components. You may certainly exploit such capabilities as you nd them.
However, since we can only ensure the completeness or accuracy of NAD code-libraries, we cannot
support the HTR 3’s operation with other-brand components.
OPERATION
USING THE HTR 3 REMOTE CONTROL
43
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ
