493495
18
Verklein
Vergroot
Pagina terug
1/44
Pagina verder
DSP OPTIONS
LIP SYNC DELAY
DSP Options has the feature “Lip Sync Delay” whose function is to match
any delay that may occur in the picture relative to the audio.
By varying “Lip Sync Delay from 0ms to 120ms, one can delay the audio
output in order to synchronize it with the video image.
TONE CONTROLS
The T 757 has two Tone Control levels – Treble and Bass. Bass and Treble
controls only aect the low bass and high treble leaving the critical
midrange frequencies free of coloration.
These controls allow one to tweak on-the-y, the frequency response
of the source during playback. The control setting could be adjusted by
navigating through the Tone Controls OSD menu via a combination of
[ENTER] and [ A/S/D/F ] keys.
Maximum and minimum values for all three Tone Control levels are ±10 dB.
Tone Defeat” gives one the choice of varying or completely bypassing
the tone control section of the T 757. If “O (“Tone Active” in the VFD) is
selected, the Tone Control circuits are active.
Select “On” (“Tone Defeat” in the VFD) to bypass the Tone Controls eectively
defeating the eect of the tone control circuits.
ZONE CONTROLS
Depending on the settings made at the separate “Zone Setup menu
under the “Setup Menu” section discussion, Zone 2 can be congured and
managed via this “Zone Controls” window.
Select “On” to activate Zone 2. When activated, the Source input for Zone
2 can be allocated by selecting through the following inputs – All enabled
Sources, Front Input, Media Player, Tuner and Local.
As long as the associated Source input is active, it will continuously be
available at ZONE 2 output port in the rear panel regardless of the Main
Zone settings. For example, while the T 757 is at Source 1 mode, you can
set the Zone 2 Controls “Source item to “Source 3”; the active Source 3’s
audio output will be directed to ZONE 2 output port in the rear panel even
though the T 757 is at Source 1 mode.
You can then feed the ZONE 2 jacks to another amplier or receiver
that maybe located in another area of your home or building. With your
separate amplier or receiver selecting the fed signal and with speakers
connected, you can then enjoy the zone selected source’s audio signal.
Select “Local” as your selected Zone 2 Source input if you wish to enjoy the
same source as the main Zone and allow simultaneous listening, but with
full separate volume levels.
If a Zone 2 is set to “O, it is deactivated or powered o.
IMPORTANT NOTICE
Only analog audio connected through a Sources analog audio input
port can be associated as audio source for Zone 2. Digital audio sources
connected via HDMI, digital optical and digital coaxial input ports
cannot be downmixed and used as Zone 2 audio source. Ensure also
that the associated Source’s Digital Audio setting is set to “O” or no
actual digital source is connected.
VOLUME
Volume refers to the adjustable secondary Zone 2 Volume level that can
be increased or decreased depending upon its settings. This is applicable
only if the Zone 2 Volume setting in the separate “Zone Setup menu under
“Setup Menu” is set to Variable. If set to “Fixed”, this “Volume item at the
Zone Controls section will not be available.
NOTES
• IfZone2isstillONandSTANDBYbuttonispressedtoswitchtheT757
to standby mode, the VFD will be extinguished but the STANDBY LED
remains illuminated blue. This indicates that Zone 2 is still active. In
order to completely shut down the T 757 together with Zone 2, press and
hold STANDBY button until the STANDBY LED turns amber.
• Zone2isaudioonlyandnotassociatedwithanyvideoinputsources.
OPERATION
USING THE T 757  MAIN MENU
18
ENGLISH PORTUGUÊSFRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ
18

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

NAD-T-757

Zoeken resetten

  • Ik heb nu al enkele malen meegemaakt dat het volume volle bak aangaat uit zichzelf, dit is niet zomaar hard maar super hard. Ik heb toen op de uit knop gedrukt maar deze sprong 2 seconden later uit zichzelf weer aan.
    Ook heb ik het een keer gehad dat ik het zachter wilde zetten door aan de volumeknop te draaien, deze volumeknop gaf echter zoveel weerstand dat ik de knop met 2 handen moest terugdraaien, maar er bleef weerstand op zitten en moest weer heel de stroom eraf halen
    Weet iemand hier de oorzaak van maar vooral hoe is dit te voorkomen ( ik kan nu niet meer de radio aanlaten als ik bijvoorbeeld even naar de winkel moet) Gesteld op 15-1-2022 om 10:34

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw NAD T 757 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van NAD T 757 in de taal/talen: Engels als bijlage per email.

De handleiding is 3,73 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van NAD T 757

NAD T 757 Gebruiksaanwijzing - Nederlands - 44 pagina's

NAD T 757 Gebruiksaanwijzing - Deutsch - 44 pagina's

NAD T 757 Gebruiksaanwijzing - Français - 44 pagina's

NAD T 757 Gebruiksaanwijzing - Italiano - 44 pagina's

NAD T 757 Gebruiksaanwijzing - Português - 44 pagina's

NAD T 757 Gebruiksaanwijzing - Espanõl - 44 pagina's

NAD T 757 Gebruiksaanwijzing - Svenska - 44 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info