5.0 Connecting the Thermostat
6.0 Thermostat User and Installation Guide
Electric Underfloor Heating10
Fig. 23 Fig. 24 Fig. 25
CAUTION: Mounting in plastic wall boxes only.
For full operating instructions, please refer to the instructions supplied with the product.
Principle of Operation:
The MYSON Programmable Floor Temperature
Controller allows programming switching events
and temperatures according to personal needs.
After installation the device automatically shows
the time of day and the floor temperature.
In AUTO mode, the heater will be automatically
activated according to programmed time and
temperature. Programme 1 is activated (see page
11). The floor temperature will be controlled
according to the temperature measured by the
remote sensor. The heater will be switched on
when the temperature drops below the current
set-point.
Installation:
CAUTION!
This device must be installed by a qualified
electrician, according to the wiring diagram on
the device and in compliance with all applicable
safety regulations. To maintain compliance with
Protection Class II, user access to the rear of the
device must be prevented. This device is used
to control the temperature only in dry rooms,
under normal environmental conditions. This
electronic device conforms to EN 60730, it is an
“independently mounted control” and works
according to operating principle 1C.
Mounting:
The controller should be mounted in a location of
the room that is easily accessible for operation
purposes.
Fitting
In a conduit box Ø 60 mm (fig 23).
l
Remove the display unit
l
Remove the frame
l
Mount it following the reverse procedure
The plastic tab must be in place to provide
insulation between the terminals/wires and the
mounting screw (fig 24).
l
To insert or remove a flexible wire press pin
(fig 25)
