09Electric Underfloor Heating
3.5 Installation: Other Possibilities
You can also use any section that you have left
over within the wall or a step to the bath. You can
include it in the plaster layer or apply it with tile
cement. This maximises the effective heating area
from your mat.
TIP: A MYSON Towel Warmer will give you the
comfort and convenience of warm dry towels, to
add to the luxury of your warm floor. This may
also give the benefit of additional heat. Please
contact Customer Services on 0845 402 3434 for
a Design Collection brochure.
4.0 Measuring Values/Resistance with the Multimeter
l
Connect the wires to the multimeter (fig 19).
l
Turn the knob of the multimeter to the Ohm
2000 position (fig 20).
l
Connect the red and black probe to the
connection wires (fig 21). The connection wires
(Phase and Neutral) have a clear insulation
sheath.
l
Do not touch the wires when measuring. Check
readings according to the control card which
was attached to the heating mat. If readings are
not within a 5% margin please check again
to make sure. Please call 0845 402 3434 and
cease installation if readings are not within a
5% margin.
l
Connect the RED probe to one of the
connection wires and the BLACK probe to the
Earth wire (fig 22). Earth wire has no sheath.
Repeat this step with the RED probe to the
other connection and BLACK probe to the
Earth wire.
l
Reading on the multimeter now should be ‘1’.
If you read any resistance there is a possible
break in the wires. Please check again. Please
call 0845 402 3434 and cease installation if
reading still shows resistance.
Fig. 19
Fig. 21
Fig. 20
Fig. 22
