R331 Rechargeable Remote Control
1. How to connect the Base Station
STEP 1. Determine where you would like to place the Base Station.
STEP 2A - Powering from your Set-top (within 3 feet). Connect the “square” end of the
supplied USB cable to the Base Station and the “rectangle” end to the back of the Set-top.
STEP 2B - Powering from a Wall Outlet (further than 3 feet from Set-top). Connect one
end of the supplied plug-in power supply to the Base Station and the other end to a near
by wall socket.
Note: you only need to follow STEP 2A, or STEP 2B, not both.
2. How to set the clock
STEP 1. Use the +H and the +M buttons on the bottom of the Base Station to set the
hours and minutes of the clock.
STEP 2. With the remote control in the Base Station, press and hold the FIND button
which will cause the clock to dim as desired. Press and hold the FIND button again to
make clock brighter as desired.
3. How to charge the remote control
STEP 1. Place the remote control in the Base Station. A magnet inside the Base Station
pulls the remote into place to make contact with the charging pins.
STEP 2. Make sure that the charging points are in full contact by seeing that the charging
lights on the Base Station are lit.
NOTE: It is not necessary to charge the remote control often, but remember to place it in
the Base Station for at least two overnight sessions per month if possible. Quick charge
the remote in 30 minutes or fully charge the remote in 12 hours.
4. How to manually setup the remote
STEP 1. Power on the device you want to setup.
STEP 2. Locate the 4-digit code from the code list (see pages 29 and 30).
STEP 3. Press and hold the mode key (TV, DVD, or AUX) and while holding the mode
key, press the OK key.
STEP 4. Release both the mode key and the OK key. All the mode keys flash but the
selected mode key stays on.
STEP 5. Enter the 4-digit code from the code list. The selected mode key light blinks for
each digit entry and remains off after the entry of the fourth digit.
STEP 6. Point the remote control at the selected device and press the power key once.
The device should turn off if you have found the correct 4-digit code.
STEP 7. If there are multiple codes and one does not work, repeat steps 2-6 using the
next code until you find the correct one. If it still does not work as intended, please refer to
the advanced section starting on page 9.
Write your codes here so you don’t forget them.
TV________ DVD________ AUX________
