English
10
3) Push the support back into the remote
control.
6 Operating the Amplifier
1) To switch on the amplifier, use the
POWER switch (12). The LED POWER (1)
will light up in blue.
The operating mode will be indicated
by the corresponding LED, lighting up in
green:
– LED LINE IN (2) lights up:
The audio source at the input LINE IN
(8) has been selected.
– LED BLUETOOTH (3) lights up:
The Bluetooth mode has been selected.
Information on operation with a Blue-
tooth source can be found in chapter 6.1.
To switch between the operating modes,
press the control knob (5) at the amplifier
or use the corresponding button on the
remote control (button AUX = source at the
line input, button = Bluetooth mode).
2) To adjust the volume, turn the control
knob (5) at the amplifier or use the buttons
VOL+ and VOL
-
on the remote control.
3) To mute the sound, press the button
MUTE on the remote control. The LED
POWER (1) will flash while the sound is
muted. To unmute the sound, press the
button again.
4) To switch to the standby mode, press
the button POWER on the remote control.
The LED POWER (1) will light up in red. To
switch on the amplifier, press the button
POWER again.
Auto standby:
– in the operating mode “LINE IN”:
If the amplifier does not receive any
audio signal via the line input, the am -
plifier will automatically switch to the
standby mode after 15 minutes. As soon
as a signal is available at the input, the
amplifier will be switched on again.
– in the operating mode “Bluetooth”:
If the amplifier does not receive any
audio signal from a Bluetooth source,
the amplifier will automatically switch to
the standby mode after 15 minutes. If
the Bluetooth connection is still available
(e. g. because the source has not been
switched off but set to pause), the ampli-
fier can be switched on again by starting
the replay at the source.
5) To switch off the amplifier, use the
POWER switch (12).
If the amplifier is not used for a longer
time, disconnect the power supply unit
from the mains socket. The power supply
unit has a low power consumption even
when the amplifier is switched off.
6.1 Operation with a Bluetooth source
1) The amplifier must be in the operating
mode “Bluetooth”, indicated by the LED
BLUETOOTH (3). The LED will flash if no
Bluetooth connection has been estab-
lished.
2) At the Bluetooth source, switch on the
Bluetooth function. On the display of the
Bluetooth source, the SA-160BT will be
indicated by “BT Speaker”. Pair the source
with the SA-160BT (please refer to the in -
struction manual of the Bluetooth source,
if required).
Once the pairing has been made, the
LED BLUETOOTH will light up constantly.
CAUTION Never adjust a very high vol-
ume. Permanent high volumes
may damage your hearing!
Your ear will get accustomed
to high volumes which do not
seem to be that high after
some time. Therefore, do not
further increase a high volume
after getting used to it.
Never put batteries in the household
waste. To protect the environment,
always take them to a special waste
disposal, e. g. collection container at
your retailer.
