20
WebCam Driver (for all Windows versions from Windows 98SE)
Insert the DD100 CD-ROM in your CD-ROM drive and
connect the DD100 to your computer using the provided USB
cable.
1. Switch on the DD100 with the Power On/Off button and
actuate the Mode button 2 times to access the setup mode.
2. Using the
ᮡ
/T button (up) and the
ᮢ
/W button (down)
you can move around the menu selection. Select "Web-
cam" and confirm with the OK/Menu button. On the mo-
nitor (TFT) you will see the WebCam image.
3. Insert the smaller USB connector into the USB port of your
DD100 (on the left hand side of the camera)
4. Insert the larger USB connector into the USB port on your
computer.
5. The DD100 is BUS-powered.This means the USB port pro-
vides the DD100 with power as soon as it is connected
to the computer and switches it on automatically.
6. The computer/operating system recognizes the
DD100 as a new device.You are then requested to install
the appropriate driver.
7. Follow the instructions on the screen to complete the in-
stallation of the WebCam driver.
Note:
The WebCam driver runs under all Windows versions as from
Windows 98SE.Always make sure that the CD-ROM for the
DD100 is in the CD-ROM drive before you connect the
DD100 to your computer for the first time!
Important:
MacOS only transfers still pictures. The Web Cam mode is
not supported by MacOS.
Important note for Windows XP
At the time of introduction of this product Microsoft urgent-
ly recommended all companies to send in their hardware so-
lutions for certification. If a hardware device driver has not
been certified through Microsoft, a warning sign appears.
This message may possibly appear upon installation of this dri-
ver or its update. Should this occur, you can click on the but-
ton "continue anyway". Minox has tested this driver and its
update on Windows XP and confirmed that it will not im-
pair or destabilize your computer.
