info@metronic.com.
8
B - Wedging / adjusting the aerial
If no channels have been found through your current antenna, it means
that it probably is pointing towards an analogue only transmitter. If your area
is covered by digital, it means that the programs are coming from another
transmitter.Youwillhencehavetoadjusttheantenna.Therearetwopossible
options, as follows :
Option 1
You know at least one network number (between 21 and 69) used
in your area.
• GotoMenu/Setup/Service Setup
/xxxx / Manual Scan.
• Pressthe4 arrow until the number
oftheUHFnetworkthatemitsdigital
channelsappears(seechannelslist
page25).
• On TxMode, select 2k with
the 4arrow.
• OnGuard Interval , select 1/32 with
the 4arrow.
• Waitforafew secondsandmonitor
the Quality and Level graphs.
• Swiveltheantennatomaximisereception.Whenyougetneartheemitter,
the Signal Level should increase, and then the Quality. 6 is the lowest
number for a stable image. If the Level does not increase, this means that
you have chosen an incorrect network number, or that the emission is too far
from your antenna.
• OnceyouhavereachedthemaximumLevel / Quality, screw the antenna
tightly.
• PressEXIT.
• GotoMenu/Setup/Service Setup/xxxx / Fullscan Replace Existing
Services.