1. Make sure that the TV is ON.
2. In the code book enclosed,
look for the brand of your TV
and make a note of the first
code indicated BENEATH
the brand previously identified
(e.g. Philips TV 075).
3. Hold down the SHIFT
and ON/OFF keys together
until the light indicator at the top
starts to flash indicating that the
remote control is in programming
mode.
4. Release the keys and press the
numeric key 8 once. Within
the next 15 seconds, key in the three
figure code you noted previously
(e.g. 075).
Three flashes indicate that the code
has been saved correctly. If not, try
the code entry procedure again from
point 3.
Additional check
Point the remote control at the TV.
Check that the appliance responds
correctly to the commands sent.
If there is no response or the appliance
only responds partially or incorrectly,
it is probable that you have used
the wrong code. In this case, try the
procedure again from point 3.
This time, however, use the
NEXT CODE in the list (e.g. 099).
Note down the TV code used to program
the remote control on the adhesive label
inside the battery cover for rapid
consultation.
NOTE: THE LIGHT INDICATOR
STOPS FLASHING
The remote control leaves the
programming mode and the light indicator
stops flashing:
• if no keys are pressed for 15 seconds
• if an invalid brand code is entered.
8
0
7
5
DIRECT CODE ENTRY
FOR REMOTE CONTROLS VERSIONS
V5 - V6
B
DIRECT CODE ENTRY
FOR REMOTE CONTROLS VERSIONS FROM
V1 TO V4
B
PAY ATTENTION TO THE REMOTE CONTROL VERSION
1. Make sure that the TV is ON.
2. In the code book enclosed,
look for the brand of your TV
and make a note of the first
code indicated BENEATH
the brand previously identified
(e.g. Philips 103).
3. Hold down the SHIFT
and ON/OFF keys together
until the light indicator at the top
starts to flash indicating that the
remote control is in programming
mode.
4. Release the keys.
Within 15 seconds, enter the
code previously identified
(e.g. 103). Three flashes indicate
that the code has been saved
correctly. If not, try the code entry
procedure again from point 3.
Additional check
Point the remote control at the TV.
Check that the appliance responds
correctly to the commands sent.
If there is no response or the appliance
only responds partially or incorrectly,
it is probable that you have used
the wrong code. In this case, try the
procedure again from point 3.
This time, however, use the
NEXT CODE in the list (e.g. 111).
Note down the TV code used to program
the remote control on the adhesive label
inside the battery cover for rapid
consultation.
NOTE: THE LIGHT INDICATOR
STOPS FLASHING
The remote control leaves the
programming mode and the light indicator
stops flashing:
• if no keys are pressed for 15 seconds
• if an invalid brand code is entered.
1
0
3
