9 [EN]
Control Panel
---------------------------------------------------------------------------------------------------------------------------------------
Please note the Heat LED will only show on the display if you have a CH (Cooling and Heating)
model.
Power
When first plugged in the portable air conditioner will enter standby mode. All lights on the display will
turn on for one second and then switch off (apart from the Power Button which will continuously stay lit
up). Press the Power Button to switch the unit on – the unit will enter the default Fan Mode and the
default temperature (23°C). The compressor will start working with a 3-minute delay. Press the Power
Button again to turn the unit off, the compressor will stop at once and the fan will stop ten seconds after
the Power Button has been pressed.
Mode
Press the Mode Button to scroll through the available modes: Cool, Dry, Fan, Sleep and Heat. (Heat is
only available on the CH models). An LED light will indicate which mode is currently in use.
Up and down
Use the UP and DOWN buttons when choosing a desired temperature or setting the On or Off Timer.
Timer
Use the Timer Button to set either an On or Off Timer between 1 and 24 hours (see page 11 for
instructions).
Fan speed
Use the Speed Button to select either Low, Middle or High Fan Speed. This function is disabled in Dry
and Sleep Mode. An LED light will indicate which mode is currently in use.
Swing
Use the Swing Button to turn the automatic louvre on and off. The louvre must be left open whilst the
machine is in operation – it is optional as to whether the louvres are stationary or moving.
Sleep
Use the Sleep Button to turn Sleep Mode on and off. The portable air conditioner will run on Low Fan
Speed only to reduce the noise level and the LED display will dim.
