GB
Door Type: Sectional Door, Special 302 emergenev release, item no.: 564 453
Lock version with side locking bolts
Push the angle bracket (A) onto the left bolt of the door lock (B). Shorten the bowden cable
(if necessary) and secure to the angle bracket with the adjusting screw (C).
From behind insert the hexagon screw of the screw nipple (D) through the drill hole of the lock
bolt and screw into the screw nipple. Push the cable through the screw nipple and screw tight.
With some door makes, the hole in the lock bolt will require drilling. Drill at a distance of
48 mm from the left edge of the lock case, using a 5.5 mm ø drill bit.
Using the supplied fixings (E), fix the bowden cable to the door connector attachment (F) and
centre hinges (G). Choose the shortest distance from the carriage to the door lock, avoiding
overtaut windings.
Important:
Set the bowden cable with adjusting screw (C) so that
the lock angle bracket fits snugly against the lock case!
O
3a
Door type: sectional door, Special 302 emergency release, item no. 564 453,
lock version without side locking bolts.
(Shown is the inside right lock version.)
Remove inside door handle (A) and moving bar (B) from the door lock (four-edge pin) and screw
the mounting angle (D) onto the lock body by using the fixing screw (C ) of the lock.
If necessery, shorten the bowden cable and fix it to the mounting angle with adjusting screw (E).
Push moving bar (B) and unlocking lever (F) onto the four-edge pin.
Run the hexagonal screw of the screw nipple (G) through the unlocking lever (F) (according to
drawing). Push the wire through the drill hole of the screw nipple and fix it. Attach the inside
door handle again and screw it on.
Use enclosed fixings (H) to fix the bowden cable to the door connector attachment (I) and to the
centre hinges (J).
Choose the shortest distance from the carriage to the door lock. Avoid overtaut windings.
Important:
Set the bowden cable with the adjusting screw (E) and screw nipple without play.
Important:
The red plastic slide bar (drawing 1c, position E) of the flat carriage has to be put back
into it's front operating position after adjustment of the bowden cable
(symbol 'door closed'). Please also see point 7.
O
3b
